Rear tire wear with current setup

Z-Girl 12

Amin if I'm posting in the wrong section please move-thanks in advance!

So I installed my coils, spacers and rear camber kit at 7100mi and am just about to hit 12k when I noticed some inner rear tire wear. I know you have to pay to play but should the inner rears wear so much even with a rear camber kit? Is the rear SPC doing what it should? I didn't think it was that low...I can get a finger between the tire and fender. Is that considered too low? I'm just curious how much life everyone else is getting with a similar setup. Boy negative camber sucks! Any thoughts from you guys/gals? Thanks bunches!

__________________
2012 Z-SOLD
2014 Nismo #565 Fast Intentions CBE/HFC/Swift/SPC/RJM/H&R-15/20mm/Z1 CAI/Headers/Intake Manifold w/Uprev Tune 328.31whp/263.64tq

DEpointfive0

I JUST saw this and I don't know if you mean Admin, or Amin, (I am Andrew Amin, LOL)


Drop wise, you're not too low. Is your current camber kit adjustable?

And is it possible that your first 5k miles did the majority of the wear?
I'm 100% stock suspension wise and at 13k miles I just noticed how bad the camber wear is, I have 3-4/32nds on the inside and 6-7/32nds on the outside.
AND I get my alignment done every 5k miles, AND I tell them to make it as straight as possible

Z-Girl 12

When I got my alignment the guy told me that he squeezed as much out of the rear camber he could (so I assume my SPC rear camber kit is adjustable). And I guess I didnt take into consideration the first few thousand miles because I drove it like I stole and no VDC ALOT! So maybe that and the negative camber is about right with the wear. Just trying to gauge others wear...my slippery light on the dash flashes alot too

How are you wearing like that on stock suspension? Weird!

__________________
2012 Z-SOLD
2014 Nismo #565 Fast Intentions CBE/HFC/Swift/SPC/RJM/H&R-15/20mm/Z1 CAI/Headers/Intake Manifold w/Uprev Tune 328.31whp/263.64tq

DEpointfive0

LMAO!!!

Well, I believe stock camber settings are at 1.5-2 degrees of camber, which is great if you track and such, but I'm still a student, and I DD the damn thing, lol

ericzmyers

Had to replace my re50s on the rear from the stock set up within 18k miles.i wore thought the damn wear bars before I noticed! Switched to the re760 sport tires, still Protenzas but you get a little more out of them 360 tread wear vs 140 on the RE50A. I've slowed down a bit lately also..... Speeding tickets do that I guess. But it does seem that the stock camber is a tire eater especially with the softer composite RE50A.

__________________
Eric Z. Myers
2011 370Z, Silver, Sport, K&N short ram intake, Fast Intentions Exhaust, Pioneer AVIC, ORACLE Lighting LED Halo Kit, Tinted.

wheee!

You say you replaced your camber arms, but did you replace the toe bolts too?

I am running 305's with -1.2 camber and almost 0.00 toe (perfectly straight). My tires are wearing VERY evenly so far with 4000km's on them to date. I just had some wheel work done so I had them swap sides on the tires as well so they wear even more evenly in the future...

__________________

Z-Girl 12

[QUOTE=wheee!;2073205]You say you replaced your camber arms, but did you replace the toe bolts too?

Good question...but yes I replaced the toe bolts too

__________________
2012 Z-SOLD
2014 Nismo #565 Fast Intentions CBE/HFC/Swift/SPC/RJM/H&R-15/20mm/Z1 CAI/Headers/Intake Manifold w/Uprev Tune 328.31whp/263.64tq

clintfocus

yeah not only does the car come with alot of rear static camber from the factory, but also the rear suspension has alot of camber gain under compression. So daily driving with bumps, dips, etc. the Suspension and the wheel are articulating alot.

Z-Girl 12

[QUOTE=ericzmyers;2073191]Had to replace my re50s on the rear from the stock set up within 18k miles.i wore thought the damn wear bars before I noticed! Switched to the re760 sport tires, still Protenzas but you get a little more out of them 360 tread wear vs 140 on the RE50A. I've slowed down a bit lately also..... Speeding tickets do that I guess. But it does seem that the stock camber is a tire eater especially with the softer composite RE50A.
I am definitely going to look into the re760's as replacements! I guess if I'm at 11.5k I'm doing pretty average.

__________________
2012 Z-SOLD
2014 Nismo #565 Fast Intentions CBE/HFC/Swift/SPC/RJM/H&R-15/20mm/Z1 CAI/Headers/Intake Manifold w/Uprev Tune 328.31whp/263.64tq

wheee!

Well, like others have mentioned, the stock sport tires are very soft and the stock camber is around - 1.7
The damage may have been done before the camber arms were installed or the car lowered. My stock rubber only lasted 17,000km's....

__________________

Z-Girl 12

Thanks guys...guess I'm still within the range for such soft rubber.

__________________
2012 Z-SOLD
2014 Nismo #565 Fast Intentions CBE/HFC/Swift/SPC/RJM/H&R-15/20mm/Z1 CAI/Headers/Intake Manifold w/Uprev Tune 328.31whp/263.64tq

RonRizz

true. I'm all stock, and i got less than 12k out of my factory rubber. (and I'm an old man with a light right foot!!)

__________________
P99rs Head Unit--- Amps- 2 Pioneer Prs800d --- Zapco ST1000MX---Zapco ST-4XSQ---- SI BM mk5 Subs---SI TM65v2 Midbass--- SI M3 mids--- SI M25 xbl2 tweeters ----- 2016 MECA street class 3rd place at world finals

FlawlessZ

I recently got megan racing springs (1.5 drop all around) + 18x10 18x12 enkei wheels...Im running hankook RS3's so I dont want to wear them wrong and I assume I need the camber bolt kit. I tried getting the alignment today took it to 3 shops everyone wanted to charge me like $160-$200 for the alignment. Firestone considered the Z an "exotic" and raised the prices, American tire depo said they cant even touch my camber setting since my car is lowered...this is just a pain in the A$$$.

I think im going to get the bolt kit, install it and just take it to a local recommended guy that will probably only charge me $100 for alignment.

__________________
2012 PW - 6MT | Meisterschaft CBE w/ ECV | EVO-R Front Lip | Enkei SP3-RS JDM Wheels | Sticky Hankook RS-3's | Megan Racing Springs | Hot Shift Knob | JDM Brake/Fog Light

wheee!

You are getting robbed. An alignment with a camber and toe kit is super easy. $100 max. Just make sure your car can make it onto the ramp! I drove mine on myself.

__________________

Hotrodz

I had Tein S and H&R 15mm installed on mine. They are pretty much within the specs for the given range for the Z. My shop, an independent dealer only charge $75 for the alignment.

__________________
Fast Intentions TT Installed and Tuned by Seb at SpecialtyZ 610whp 560tq:|Fast Intentions 3" TT-TDX|SpecialtyZ/Fast Intentions 72 Row Oil Cooler|SZ 6 Puck Clutch & Flywheel|3GsCustoms|Z1|Wavetrac|Hotchkis|Whiteline |Blitz|Fortune Auto 500|Fujimura|SPL|H&R|TK|TWM|RPM Rollbar|Sparco|Next Level Performance|TrackSpec|AeroFlow Dynamics|Pioneer|