Z1 Master cylinder brace installed.

HisStigness · 05-16-2018, 02:00 AM

Sort of bringing this thread back from the dead. I just installed my brace and had a similar issue of only being able to get two of the three bolts in, but for me I got the upper and lower ones. The middle bolt didn’t seem to quite line up properly, there are marks on my brace from the screw grinding on it as it tried to thread so I bailed on that middle bolt.

As far as the main bolt and jam nut, do you guys think more or less finger tight is okay? I only had access to a normal length 19mm wrench, I snugged the bolt as best I could by hand against the master cylinder, and was only able to maybe get a quarter turn with the wrench on the jam nut after finger tightening it before the angles didn’t allow me to go any further with the wrench. Want to see what you all think.

Rusty · 05-16-2018, 07:00 AM

Got all 3 bolts in mine. Try and just the jam nut tighter. You will have to flip-flop the wrench around to do it. And take baby bits.

05-16-2018, 07:00 AM	#2 (permalink)
Rusty A True Z Fanatic Join Date: Dec 2011 Location: Fayettenam,Pennsyltucky Age: 70 Posts: 35,578 Drives: 2011 Nismo GM 6M Rep Power: 2684440	Got all 3 bolts in mine. Try and just the jam nut tighter. You will have to flip-flop the wrench around to do it. And take baby bits. __________________ 浪人 - 殺し屋 "The Difficult Anytime, The Impossible By Appointment Only" http://www.the370z.com/members-370z-...o-journal.html

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Prototype Aftermarket Clutch Master Cylinder - INSTALLED!	Alstann	Engine & Drivetrain	41	04-21-2016 11:30 PM
Bad Master Cylinder?	ARrado15	Engine & Drivetrain	6	04-17-2016 04:30 AM
Master cylinder	Elmo370z	Engine & Drivetrain	4	01-05-2015 01:21 PM
I think my master slave cylinder or maybe CSC just went	dmhenderson	Mid-Atlantic Region	89	04-11-2013 09:22 PM
Clutch master cylinder went out again	Zenmaster	Engine & Drivetrain	4	03-26-2013 12:54 AM

05-16-2018, 02:00 AM	#1 (permalink)
HisStigness Base Member Join Date: Jan 2014 Location: San Ramon Posts: 65 Drives: 10 370Z Sport 6MT Rep Power: 13	Sort of bringing this thread back from the dead. I just installed my brace and had a similar issue of only being able to get two of the three bolts in, but for me I got the upper and lower ones. The middle bolt didn’t seem to quite line up properly, there are marks on my brace from the screw grinding on it as it tried to thread so I bailed on that middle bolt. As far as the main bolt and jam nut, do you guys think more or less finger tight is okay? I only had access to a normal length 19mm wrench, I snugged the bolt as best I could by hand against the master cylinder, and was only able to maybe get a quarter turn with the wrench on the jam nut after finger tightening it before the angles didn’t allow me to go any further with the wrench. Want to see what you all think.