The "Will it fit?" thread

[BrockDM1]

I am looking to put my old set of Vossen CV5's on my 15 Nismo in the spring. They are 20x9+35 245/35 and 20x10.5+45 275/30.

I was wondering what a good size spacer to run would be?

I dont want it too aggressive because the new Nismo has fender flares that stick in the wheel well more than the fender does.

I am lowered on coilovers, from the center of the fender to the ground is 26.25" in the front and 26.5" in the rear.

Thanks

[CM370z]

Originally Posted by BrockDM1

I am looking to put my old set of Vossen CV5's on my 15 Nismo in the spring. They are 20x9+35 245/35 and 20x10.5+45 275/30.

I was wondering what a good size spacer to run would be?

I dont want it too aggressive because the new Nismo has fender flares that stick in the wheel well more than the fender does.

I am lowered on coilovers, from the center of the fender to the ground is 26.25" in the front and 26.5" in the rear.

Thanks

If I were you, I'd run a 15mm spacer up front to give you an end offset of +20 and a 30mm on the rear for an end offset of +15. You shouldn't have any rubbing issues with this setup.

[BrockDM1]

Originally Posted by BrockDM1

I am looking to put my old set of Vossen CV5's on my 15 Nismo in the spring. They are 20x9+35 245/35 and 20x10.5+45 275/30.

I was wondering what a good size spacer to run would be?

I dont want it too aggressive because the new Nismo has fender flares that stick in the wheel well more than the fender does.

I am lowered on coilovers, from the center of the fender to the ground is 26.25" in the front and 26.5" in the rear.

Thanks

So i posted this in the past and I had a quick question.

I am going to run a 15mm front spacer and a 30mm rear but my biggest concern is will it rub on the 2015 Nismo fender flares? I know guys were saying no but im not sure if they were basing that off of a regular z fender.

[Anthony@Royal]

Originally Posted by BrockDM1

So i posted this in the past and I had a quick question.

I am going to run a 15mm front spacer and a 30mm rear but my biggest concern is will it rub on the 2015 Nismo fender flares? I know guys were saying no but im not sure if they were basing that off of a regular z fender.

Regular Z fenders or Nismo doesn't matter. The nismo "fender flares" are just little side moldings added onto the regular Z fenders. Regardless, you should have any issues with those sizes.

[BrockDM1]

Originally Posted by Anthony@Royal

Regular Z fenders or Nismo doesn't matter. The nismo "fender flares" are just little side moldings added onto the regular Z fenders. Regardless, you should have any issues with those sizes.

My concern was the flares have a lip that stick into the fender-well so i didn't know if that would cause rubbing.

Thank you though!

[Anthony@Royal]

Originally Posted by BrockDM1

My concern was the flares have a lip that stick into the fender-well so i didn't know if that would cause rubbing.

Thank you though!

I see what you're saying. Are you planning on lowering the car?

[BrockDM1]

Originally Posted by Anthony@Royal

I see what you're saying. Are you planning on lowering the car?

It is lowered on Tein street flex coils. Roughly around an inch, no camber kits

Pic for reference

[Anthony@Royal]

Originally Posted by BrockDM1

It is lowered on Tein street flex coils. Roughly around an inch, no camber kits

Pic for reference

Should be good. Your specs aren't too aggressive even with the spacers on there.