Ecutek launch control on Manual Transmission

Originally Posted by Niksmo

I had some questions on Lauching a Manual Z using the EcuTek Lauch control. I have a Ecutek tune by Dynosty on my Z and everytime I try launching the vehicle using the Launch control, it always tends to spin the wheels till redline. I'm not sure if I'm doing it right, and hope someone can chime in.



1. Auto Rev Match ON

2. First Gear

3. Hold the clutch and Plant the throttle. Engine RPMs hold at 4k

4. Cruise control down button to set RPM to 2-2.5k

5. Dump the clutch with throttle at 100%



I tried this with Traction control ON, and OFF. With DTC OFF, The tires break lose as soon as I dump the clutch. With DTC ON, it cuts power.

Do I have to reduce and modulate throttle input as soon as I let of of the clutch? I assumed the RPMs will hold at Set RPM until the tires hook up (similar to vehicles which come stock with Launch control), but it just starts spinning all the way to the red line. Had much better launches without using this feature and by feathering the throttle. Am I not doing it right?