Velox rear diffuser

secondnissan

2017-09-22 01.52.11.jpg

2017-09-22 01.53.04.jpgHere are some photos of the front bracket being narrowed. I used tin snips to cut the diffuser on the inside of the outside slots . I then drilled two sets of holes to replace the slots that were cut out. Holes are 3/4 of an inch from sides of tab. Holes are 1/4 diameter. For the bracket I used a dremel cutting wheel and cut to match diffuser width and holes. Filed down sharp edges and painted exposed metal with flat black spray paint. Hope to fit it tomorow. Debating whether I want to cut holes for the bottom of mufflers to protrude so I can tuck the diffuser up higher.