|
1st and 2nd pic's. Was told that I couldn't use the upper side port in the Z1 cover for the return line because of the sensor location. And would have
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
03-25-2018, 12:10 AM
|
#10 (permalink) |
|
Ronin Samurai - Assassin
 
Join Date: Dec 2011
Location: Fayettenam,Pennsyltucky
Age: 69
Posts: 35,494
Drives: 2011 Nismo GM 6M
Rep Power: 2684438   |
1st and 2nd pic's. Was told that I couldn't use the upper side port in the Z1 cover for the return line because of the sensor location. And would have to use the bottom, fill port for the return.
3rd and 4th pic's. Found a way to use the upper port. Used a banjo fitting. AN 08 x 18mm. x .150 with an elbow installed on it. The return line goes over the top of the sub-frame.
__________________
 浪人 - 殺し屋 "The Difficult Anytime, The Impossible By Appointment Only" http://www.the370z.com/members-370z-...o-journal.html Last edited by Rusty; 03-25-2018 at 01:29 AM. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Z1 Motorsports 25 row oil cooler install | falconfixer | DIY Section (Do-It-Yourself) | 5 | 05-30-2014 04:32 PM |
| 7AT 4.08 Gear swap QUAIFE LSD Trans cooler diff cooler | matcop | Engine & Drivetrain | 17 | 09-07-2013 10:09 AM |
| Akuma Motorsports Rear Diff Cooler | Kevin@AkumaMS | Engine & Drivetrain | 24 | 05-23-2013 08:01 PM |
| Z1 Motorsports Thermostatic Sandwich Plate kit (For Nissan Motorsports Oil Cooler) | Dustin@Z1 | Drivetrain/Engine | 3 | 06-08-2012 11:10 AM |
| DIY: GT Motorsports Oil Cooler Kit Install/Review | rackley | DIY Section (Do-It-Yourself) | 28 | 03-10-2010 10:38 AM |
153Likes
Threaded Mode
