So I've decided to do my own oil changes and perhaps tackle some bolt-ons in the future. I bought two pairs of jack stands to get the car off the
|
|
LinkBack | Thread Tools | Display Modes |
07-23-2009, 03:07 PM | #1 (permalink) |
A True Z Fanatic
|
Jack Stand Question
So I've decided to do my own oil changes and perhaps tackle some bolt-ons in the future. I bought two pairs of jack stands to get the car off the ground. Then while unpacking them, I see the label on the stands which says "should be used in pairs on ONE END OF THE VEHICLE ONLY. Should not be used on both ends together."
WTF? I was hoping I could get the car off the ground and level to empty the oil pan more thoroughly. Do you guys put jack stands on all four corners or just a pair in the front? On a side note, it's a little creepy crawling under the jacked up car...lots of creaks and groans when it was going up. Boy would it suck if it came back down when I was under it... Last edited by spearfish25; 07-23-2009 at 03:10 PM. |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Oil change, Jack stands or ramps with diffuser? | spearfish25 | Nissan 370Z General Discussions | 31 | 08-10-2010 08:38 PM |
Jack Stands | Minicobra1 | DIY Section (Do-It-Yourself) | 19 | 03-07-2010 04:54 PM |
Question about oem ECU | Black kNight | Tuning | 9 | 07-13-2009 11:08 AM |
low profile jack for lowered z | jasonhoutx | Nissan 370Z General Discussions | 4 | 06-27-2009 09:38 PM |
Question | inland2000 | Nissan 370Z Pricing / Ordering Discussions | 8 | 06-07-2009 10:50 PM |