What did you do with your Z today V (ON TOPIC DISCUSSION ONLY)

kfull · 10-12-2013, 06:21 PM

Off with the 18 inch resonators, on with the non res

onzedge · 10-13-2013, 08:04 AM

My first car washing since surgery -- it felt good to clean her...

jlo370z · 10-12-2013, 07:36 PM

Got her clean for cars n coffee tomorrow

Sent from my iPhone using Tapatalk - now Free

ZMan8 · 10-12-2013, 08:13 PM

Quote:

Originally Posted by jlo370z

Got her clean for cars n coffee tomorrow

Sent from my iPhone using Tapatalk - now Free

Looking great jim

Sent from my SAMSUNG-SGH-I747 using Tapatalk 2

critical · 10-12-2013, 08:08 PM

a chunk of an aluminum wheel flew across the medium and right into my lane. The best I could do was run over it in the middle at 70mph. Was sure my car was ****** as i pulled over immediately to the shoulder and removed the chunk. Miraculously i think everything is ok. threw some weird o2 sensor codes but they're gone.

jaedub · 10-13-2013, 01:37 AM

Didn't really do anything with my Z today but I'm in a process of making her a gift

Headlight LEDs finished!

Bauran · 10-13-2013, 02:38 AM

Installed following:

B&M short throw shifter

GTR red push to start button

Nismo 32865-RN013-JP GT Ti Titanium Height Adj. Shift Knob

roy'sz · 10-13-2013, 09:23 AM

Put 108 miles on her. Went to the Costa Mesa outdoor swapmeet. Got some home made corn nuts and a couple of things for the wifey. But not before getting her washed and waxed!!! Love my Z!!!

Bauran · 10-13-2013, 07:47 PM

Installed AEM cai today, took waaaaaaay longer than I thought it would. But it is on now I just have to do a quick wire modify on the windshield reservoir stock hookups so it can hook up to the new unit.

6 hours life gone, well 12 if you count the 6 of my wife's while she "helped" me, hehe.

does it feel stronger now? Cant tell, doesn't really sound different either but it sure does look nice. Will dyno once I get my pulleys, pipes and cbe installed and get a tune.

Question, do the AEM intakes take a few miles to dial in once on the car? I.e. they get better longer you drive till they cap out optimal air/fuel?

TheGreatOne · 10-13-2013, 10:21 PM

Quote:

Originally Posted by Bauran

Question, do the AEM intakes take a few miles to dial in once on the car? I.e. they get better longer you drive till they cap out optimal air/fuel?

I would say yes, I installed Injen cold air, I'd say the computer does a bit of learning and adjusting to the increase in air...it felt better a few days in for me

TheGreatOne · 10-13-2013, 10:19 PM

21 car Z cruise into the mountains....lots of fun, nice way to close off the season

I'd say 4 370's, 4 300ZX's and the rest were 350's

A guy had one of those 6 propellor helicopter DSLR camera rig things...stole this picture off Facebook, waiting for people to upload all their stuff

critical · 10-14-2013, 01:22 AM

set off two car alarms. one at a cold start, the other driving through a parking garage lol

onzedge · 10-14-2013, 05:28 AM

Quote:

Originally Posted by critical

set off two car alarms. one at a cold start, the other driving through a parking garage lol

chops · 10-14-2013, 11:19 AM

yesterday:

- carbotech xp8's all around
- rbf600 brake flush
- z1 stainless steel clutch line
- rbf600 clutch flush
- raised the coils an inch/stiffened it up a smidge
- AK370Z gopro mount

saturday: buttonwillow!

and holy ****, the xp8's bite like crazy. ive got around 35k on the z and ive used probably 5mm worth of pad material on the stock pads. the xp8's bite with such little pedal action. and it just keeps grabbing!

Ty99 · 10-14-2013, 04:47 PM

I got this on

AND
will install this next when my camber kit comes from Source,LLC:

10-12-2013, 06:21 PM	#1 (permalink)
kfull Track Member Join Date: Mar 2012 Location: Massachusetts Posts: 909 Drives: A lot Rep Power: 15	Off with the 18 inch resonators, on with the non res __________________ 2012 GM 6MT sports package \| FI non res cf exhaust \| K&N Drop Ins \| Viper 3303 security system w/ tilt sensor \| GTR start button \| 35% rear 45% side window tint \| Michelin PSS

10-12-2013, 07:36 PM	#3 (permalink)
jlo370z Im a Fireball Join Date: Apr 2012 Location: Ill in noise Posts: 3,370 Drives: 11 370z Red 6spd Rep Power: 43427	Got her clean for cars n coffee tomorrow Sent from my iPhone using Tapatalk - now Free __________________ ❝The Jlo370Z Build❞ 523HP \| 455 ftb tq \| 11.5 PSI \| 93 Octane *2017 Porsche 991.2 C4!l*

10-12-2013, 08:08 PM	#5 (permalink)
critical A True Z Fanatic Join Date: Oct 2012 Location: Washington Posts: 1,252 Drives: 09' 370z 7AT Rep Power: 16	a chunk of an aluminum wheel flew across the medium and right into my lane. The best I could do was run over it in the middle at 70mph. Was sure my car was **** as i pulled over immediately to the shoulder and removed the chunk. Miraculously i think everything is ok. threw some weird o2 sensor codes but they're gone. __________________ Quaife w/ gears \|Stillen Gen 3\|SOLD FI Resonated Test Pipes \|SOLD FI 18'' \| 25row Stillen Race \| Progress 35mm/25mm sways \| Swifts/Koni\|Volk G25's\| Stoptech SS lines\|\|SPL Front/Rear Arms**\|

10-13-2013, 02:38 AM	#7 (permalink)
Bauran Base Member Join Date: Apr 2013 Location: NC Posts: 117 Drives: 12 370Z Nismo M6 Rep Power: 13	Installed following: B&M short throw shifter GTR red push to start button Nismo 32865-RN013-JP GT Ti Titanium Height Adj. Shift Knob Last edited by Bauran; 10-13-2013 at 02:47 AM.

10-13-2013, 09:23 AM	#8 (permalink)
roy'sz A True Z Fanatic Join Date: Aug 2011 Location: palmdale, ca Posts: 1,299 Drives: 2010 nissan 370z Rep Power: 16	Put 108 miles on her. Went to the Costa Mesa outdoor swapmeet. Got some home made corn nuts and a couple of things for the wifey. But not before getting her washed and waxed!!! Love my Z!!! __________________ https://www.youtube.com/watch?v=RtvG...data_playerARK HFC'S-ARK Grip-Stillen G3-M370-UPREV-Kinetix upper control arm-WC Latheworks-Stage2 Bad@$$ Driver(318whp/268tq)-

10-13-2013, 01:37 AM	#6 (permalink)
jaedub Track Member Join Date: Aug 2010 Location: Los Angeles Posts: 906 Drives: 2010 Black 370Z MT Rep Power: 305	Didn't really do anything with my Z today but I'm in a process of making her a gift Headlight LEDs finished!

10-13-2013, 07:47 PM	#9 (permalink)
Bauran Base Member Join Date: Apr 2013 Location: NC Posts: 117 Drives: 12 370Z Nismo M6 Rep Power: 13	Installed AEM cai today, took waaaaaaay longer than I thought it would. But it is on now I just have to do a quick wire modify on the windshield reservoir stock hookups so it can hook up to the new unit. 6 hours life gone, well 12 if you count the 6 of my wife's while she "helped" me, hehe. does it feel stronger now? Cant tell, doesn't really sound different either but it sure does look nice. Will dyno once I get my pulleys, pipes and cbe installed and get a tune. Question, do the AEM intakes take a few miles to dial in once on the car? I.e. they get better longer you drive till they cap out optimal air/fuel?

10-13-2013, 10:19 PM	#11 (permalink)
TheGreatOne A True Z Fanatic Join Date: Jan 2011 Location: Montreal, Canada Age: 47 Posts: 1,980 Drives: E60 BMW M5 Rep Power: 22	21 car Z cruise into the mountains....lots of fun, nice way to close off the season I'd say 4 370's, 4 300ZX's and the rest were 350's A guy had one of those 6 propellor helicopter DSLR camera rig things...stole this picture off Facebook, waiting for people to upload all their stuff __________________ 2017 SUBARU STI 2008 E60 M5 - SOLD 2010 40th Anniversary 370Z - SOLD (and missing her)

10-14-2013, 01:22 AM	#12 (permalink)
critical A True Z Fanatic Join Date: Oct 2012 Location: Washington Posts: 1,252 Drives: 09' 370z 7AT Rep Power: 16	set off two car alarms. one at a cold start, the other driving through a parking garage lol __________________ Quaife w/ gears \|Stillen Gen 3\|SOLD FI Resonated Test Pipes \|SOLD FI 18'' \| 25row Stillen Race \| Progress 35mm/25mm sways \| Swifts/Koni\|Volk G25's\| Stoptech SS lines\|\|SPL Front/Rear Arms\|

10-14-2013, 11:19 AM	#14 (permalink)
chops A True Z Fanatic Join Date: Oct 2010 Location: NA Posts: 1,732 Drives: NA Rep Power: 22	yesterday: - carbotech xp8's all around - rbf600 brake flush - z1 stainless steel clutch line - rbf600 clutch flush - raised the coils an inch/stiffened it up a smidge - AK370Z gopro mount saturday: buttonwillow! and holy ****, the xp8's bite like crazy. ive got around 35k on the z and ive used probably 5mm worth of pad material on the stock pads. the xp8's bite with such little pedal action. and it just keeps grabbing!

10-14-2013, 04:47 PM	#15 (permalink)
Ty99 Base Member Join Date: Jun 2013 Location: USA Posts: 14 Drives: 2013 Nismo Rep Power: 13	I got this on AND will install this next when my camber kit comes from Source,LLC:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
5D3 Discussion	FrancoPhoto	Photography	6	07-09-2012 12:08 AM
[Off Topic,GTA]Who dares to drive in the snow tonight with their Z?	Da.Menace	Canada	11	02-05-2011 05:43 PM
Double Din Dvd/Nav Feedback Topic	Carbon_z	Audio & Video	7	11-19-2010 11:10 AM
on the topic of oil ??	sonic370	Nissan 370Z General Discussions	5	07-17-2010 09:50 PM
Lounge (Off Topic) Rules	AK370Z	The Lounge (Off Topic)	0	09-23-2008 07:19 PM