Originally Posted by JARblue (Post 1802842)

Funny you should ask. I was talking to Melody about this and she said she didn't want me to put any decals on the Z still. But she said I could put them on the Acura :icon17: I'm not sure what to do except put them on both cars :tup:

Originally Posted by JARblue (Post 1802811)

:iagree: Just do what Mr. Kenchan does and post w/o bothering to go back and read :eek::rofl2:

Originally Posted by Pintsize725 (Post 1802846)

Did you explain the 35 rwhp benefit? :eek:

Originally Posted by kenchan (Post 1802847)

lol i dont have time to go back. only forward. :tup:

Originally Posted by Pintsize725 (Post 1802799)

I give up. I keep trying to catch up and then there are more posts to sort through. I'll check back in later. For now, I'm going to go drool over my car. :p

Originally Posted by kenchan (Post 1802683)

hahaha, i have the normal TWM typeR in satin in my G right now and it feels great. :tup: the satin finish actually keeps the surface cooler than normal stainless or mirror (hot :eek: finishes).

the big type-r is only considerably bigger, not HUGEGANGOUS looking at the picts, i think. :icon17: i got the standard brushed stainless one for my Z. :p

the PWJDM was fine until i mis-shifted the other week when the rear of my Z spun out about 65degrees requiring a 120 degree counter and i was trying to get into 2nd gear when the knob slipped out of my hand causing me to spill- water-from-the-cup which is a big fail. :ugh2: it was an abrupt recovery from a drift and i did not enjoy it one bit. i blame it on the knob. :stirthepot:

Originally Posted by kenchan (Post 1802878)

mr.alcheng- yes yes, i failed due to american made PWJDM knob. :icon17: inorder to correct, i must now use canadian made knob. :stirthepot:

Originally Posted by Lemers (Post 1802889)

Had my Z towed to Nissan my 1st day in Kansas. I think the clutch went out. But at least the truck was a flatbed and not a hook. And the dealership was about a mile away. They gave me an Altima as a loaner.

Originally Posted by alcheng (Post 1802893)

TWM is Canadian?? LOL.... I thought we only brew Molson...

Thank you for your support... :tup: :tup:

Originally Posted by kenchan (Post 1802902)

lol! :rofl2: yah, they are made in canada. :p

Originally Posted by shadoquad (Post 1802903)

Yes, TWM is Canadian. My knob is also a Northern Neighbour.

Originally Posted by alcheng (Post 1802893)

TWM is Canadian?? LOL.... I thought we only brew Molson...

Originally Posted by shadoquad (Post 1802903)

Yes, TWM is Canadian. My knob is also a Northern Neighbour.

Originally Posted by alcheng (Post 1802939)

ok folk... closing up the store now, gonna have more tennis racquets to strings.. :tup: :tup:

Laterzzzzzzz......... :tiphat: :tiphat:

Originally Posted by kenchan (Post 1802988)

Sounds good! :tup:

Originally Posted by onzedge (Post 1802994)

Hello Mr. Kenchan. :hello: