|
Originally Posted by Averying That’s probably the quickest I’ve heard of someone doing it. I’m guessing you gathered a big selection of extensions and swivel joints for it to go
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
11-29-2021, 06:21 PM
|
#11 (permalink) | |
|
Base Member
Join Date: Jan 2020
Location: Floriduh
Posts: 35
Drives: 16 370Z M6
Rep Power: 6716   |
Quote:
Passenger side is super easy and comes out as one unit. On the driver’s side I had to remove the cat to reach the rear manifold bolt from underneath. Trickiest parts going back were the rear most lower bolts. Tubes turn down too close to get the nut over the stud with the flange fully seated. Had to hand start them as I slid it in place and use an open end wrench to tighten…about 1/8 turn at a time. Not fun. |
|
|
|
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [MAZOC] Official "Off-Topic" Discussion Thread | m4a1mustang | MAZOC | 6670 | 09-06-2018 07:21 PM |
| What did you do with your Z today VI (ON TOPIC DISCUSSION ONLY) | AK370Z | Nissan 370Z General Discussions | 10007 | 06-08-2017 09:48 AM |
| The New "What did you do with your Z today" (with off topic replies) XVIV | eastwest2300 | The Lounge (Off Topic) | 10005 | 09-11-2015 08:57 AM |
| What did you do with your Z today V (ON TOPIC DISCUSSION ONLY) | AK370Z | Nissan 370Z General Discussions | 10148 | 06-19-2014 08:20 PM |
| The New "What did you do with your Z today" (with off topic replies) VIII | JARblue | The Lounge (Off Topic) | 10016 | 11-10-2013 11:21 AM |
16483Likes
Threaded Mode
