05-03-2015, 10:56 PM
|
#4 (permalink)
|
|
Base Member
Join Date: Aug 2009
Location: Orlando, FL
Posts: 67
Drives: '12 370Z Mag Blk 6MT
Rep Power: 17
|
Quote:
Originally Posted by dkinghl
yeah the lost power happen after i extend the tail light wire , i mean i just connect 4 new wire (16 gauge taillight wire at walmart) to the tail light wire DIRECTLY then just leave the 4 wire in the trunk
i mean may me the resistor of the 16 gauge was so big that it drain electric from the car =>causing it to lost power (this time i not even connect EVO-R to that 4 wire yet) -and also this time daylight is set to off=>so how can it drain power when you did not turn it on ?
i notice that the taillight wire is just very thin compare to the 16 gauge wire i can find at walmart.
so what do you suggest a CORRECT wired ?
|
Not sure if I understand. What happened to mine was I was using a low and high filament bulb/harness. So when I applied power to the low filament wire (from normal lights being powered on), the high filament wire (connected to my brake light) was sending power back which caused the issue. I probably could have attached a diode or something to stop the reverse flow, but instead I only power the high filament when pressing on the brake and left the low filament wire alone. Hope this helps.
__________________
Magnetic Black Touring/Sport/Navi/6MT < Stillen G3 | ZSpeed Stage 1 Clutch/Flywheel/CMAK | RJM Rev 3.2 Pedal with Tilton Master
|
|
|
Similar Threads
2Likes
Threaded Mode
