YzGyz

The kit install itself is not bad at all. I would estimate it would take good weekend (25 hrs) If you have all your tools lined up. I approve of the kit's design. The instructions for the most part is clear. There were some areas that I couldn't follow but you could post and ask for help. Quite a few people have taken on the task so there are people who can help. SASHA is pretty good with respond to e mails And pm's. I would rate the turbo install itself a 6/10.

List of things to have ready:
-clutch and flywheel to handle power goal
-tools, sockets, lots of extensions, wobble bits, large adjustable Cresent wrench
-safe flat surface and Jack stands
-some lube ( I used water based like KY) to lube up the couplers so they slide together easier
-good light to see around in
-make sure you can get the cat off
-soldering iron and shrink wrap

Hey YzGyz! I was just looking at your build thread and I was wondering how the installation of your BP turbo was and any initial thoughts or comments on the setup in general?

Check the photos in post #126 in this thread. Notice the slots in the shield under the crank. One edge of the slots is bent up toward the crank. These edges are meant to strip oil spinning with the...

My custom WP Pro BBK. 8 piston calipers and 388mm rotors for the front, and custom 4 piston calipers with 360mm roots for the rear. https://c1.staticflickr.com/1/358/18286163189_ac2cabfe2d_c.jpg...

I haven't been very active on here for a while. It was mostly because of work and GF BS drama. But with a recent breakup I needed a change! Truth be told, I have had the itch to get a GT-R for...

It's times like these it's good to remember the business triangle. Good-Fast-Cheap You can only have two at a time. All three together doesn't exist.

Stop being cheap, and save up for an exhaust. This isn't a civic. Just be happy with what you have

this reminds me of the people who buy a Z then complain about paying for 93 in the tank. don't buy the car if you can't afford the maintenance and go for ebay mods :facepalm:

Go to a local shop and have them replicate the short tail exhaust that's sold for the Z.. I had a friend get it done for about $150 and it sounds great. Look up 370z short tails. Otherwise I'd say...

Just do it, you know you want it. You've been trying to talk yourself out of it this whole page.

Has nothing to do with credit score. You should never purchase a 'want' that you can't pay for in cash, unless you get some special financing (i.e. 0%). If you do then your financial planning is...

Please tell me where for that cheap

Z1 Motorsports has the CSF radiators listed on their website for $598. Z1 Motorsports cooling (http://www.z1motorsports.com/g37_370z/index.php?cPath=597_809)

Picked up my 2010 NISMO Z a little over a month ago after being out of the car game for a little over a year. Getting it up to track spec now and hope to hit the track after the summer. It's my daily...

I considered doing that, but I didn't do it. But I sure can if you like that! I can take the same ball cutter that worked in the heat sinking surface on the bottom, and run it a little less deep to...

POST UPDATED 9/22/15 TO REFLECT PRODUCTION PART http://host.cj-motorsports.com/products/vhroilpan3.jpg ORDERING PAGE: Click Here...

So I FINALLY went and bought a sander and dremel so I could finish this bad boy. :woot: The stuff I have sitting on the top is weight for the glue. I have the laminate on both sides and the bottom of...