YzGyz

The kit install itself is not bad at all. I would estimate it would take good weekend (25 hrs) If you have all your tools lined up. I approve of the kit's design. The instructions for the most part is clear. There were some areas that I couldn't follow but you could post and ask for help. Quite a few people have taken on the task so there are people who can help. SASHA is pretty good with respond to e mails And pm's. I would rate the turbo install itself a 6/10.

List of things to have ready:
-clutch and flywheel to handle power goal
-tools, sockets, lots of extensions, wobble bits, large adjustable Cresent wrench
-safe flat surface and Jack stands
-some lube ( I used water based like KY) to lube up the couplers so they slide together easier
-good light to see around in
-make sure you can get the cat off
-soldering iron and shrink wrap

Hey YzGyz! I was just looking at your build thread and I was wondering how the installation of your BP turbo was and any initial thoughts or comments on the setup in general?

I use to spin wax. I only do EDM. it has been a while since I really spin any but a few hours is all it takes c to get decent again. I can't beat match like I did years ago, but I can still do it...

-1st: take that gasket off and put it on the underside of the manifold. -2nd: make sure everything is disconnected, sensors, vac lines, bolts -3rd: climb on top of the engine and pull like a mad...

I'm thinking of the Innovative all in one. The only problem is that it's white.. My car is black and red. Picture time! Fuel rails with 3 new injectors in:...

I cut the 90 ell and fixed the super low hanging charge pipe. It is still hanging a lot lower than I would like it to be. I will test it once I am able to start the car and drive over a 2x4 a few...

I tried all sorts of ways. Each time I moved or removed a pipe, I held my breath hoping that the silicone 90 ell did not come off. That thing is a mofo! Anyhoo, Everything is exactly like that...

Things are moving along nicely until I hit a snag. The pipe connecting to the turbo sits extremely low. ...

My clutch kit is reinstalled for the 2nd time. The transmission is backup. I don't know why but I had a heck of a time getting the darn transmission support plate to line up and bolt in right. I...

I remember ANSI and BBS boards. I remember them because I was playing computer games way back when. Heck, I still am. YzGyz

I have done that 3x now. my family saved a butt load of $$ doing it ourselves. it's not that bad as long as it's not hot as sin or wet and cold. Diy is not for everyone. Some like to pay for...

No, I soldered and then shrink wrapped the wires from my own supplies. YzGyz

No, I soldered and then shrink wrapped the wires from my own supplies. YzGyz

I remember ANSI and BBS boards. I remember them because I was playing computer games way back when. Heck, I still am. YzGyz

I have done that 3x now. my family saved a butt load of $$ doing it ourselves. it's not that bad as long as it's not hot as sin or wet and cold. Diy is not for everyone. Some like to pay for...

Thanks Wick. http://i226.photobucket.com/albums/dd107/Thangbom321/Nismo%20Boost/20150319_1328151_zpsru2nco2j.jpg...

That is what I thought. Just make make sure we are on the same book. http://i226.photobucket.com/albums/dd107/Thangbom321/Nismo%20Boost/20150319_1328151_zpsru2nco2j.jpg...