TBatt

TBatt Wrote :
Last night I found the problem. A connector was not fully seated on the transmission harness that has the hookups for the O2 sensors. There is a single wire connector that goes up near the starter motor that was not seated all of the way. When it was fixed the car started up.
--------------------
Sorry to bug you 6 years after you posted this - but i have having the same trouble (No recent work done to the car)
I checked the switch with an ohm meter and checked the fuse and the only relay i could find in the IPDM.

The wire you referred to .... where did it come from / Go to?
Thanks Tons for any help you could offer.
Dylan

PM’d you !

Crazy enough I'm in Huntsville and have been looking for a new (to me) car. I had test drove a Nismo up at Jerry Damson but it sold before I got the go ahead from my wife. I was wondering if you where available next week to meet up so that I can check out the 370. I'm Montgomery this weekend but will be back in Huntsville on Monday.

-Edward

Sorry for the slow response but I've been crazy busy at work.

Send via PayPal. My account is tbatt@knology.net

Sounds good where do I send the payment and shipping info too?

The complete kit, with shipping in the US is $175.

Hi ,
How much do you charge for your stillen idler pulley and hd belt upgrade ?

Yes, but i don't have them with me at the moment, they are at my office.

Nice car- Roll Tide ('15)!

Can you share your offsets?

Fired up my 09 Super Charged Z last night with the TDX exhaust, test pipes and Mil Spec cats. OMG! At idle it sounds almost V8 like with a very deep rumble. As the rpms go up under acceleration it...

Fired up my 09 Super Charged Z last night with the TDX exhaust, test pipes and Mil Spec cats. OMG! At idle it sounds almost V8 like with a very deep rumble. As the rpms go up under acceleration it...

Got the Z running last night. The problem was a loose connection on one of the tranny connections. Once the connector was mated properly it fired right up. The new clutch is awesome. Very nice...

Got the Z running last night. The problem was a loose connection on one of the tranny connections. Once the connector was mated properly it fired right up. The new clutch is awesome. Very nice...

Well the demon bolts lived up to their name. Dang, they are hard to break loose but I won! The CSC was just about to go out. The dust boot had already broken down and torn so it was just a matter...

The CJM fuel pump goodies were installed this weekend. I would like to say that everything worked out good but it is nearly impossible to enjoy working on the Z's fuel pump. It will fight you all the...

The CJM fuel pump goodies were installed this weekend. I would like to say that everything worked out good but it is nearly impossible to enjoy working on the Z's fuel pump. It will fight you all the...

Well the demon bolts lived up to their name. Dang, they are hard to break loose but I won! The CSC was just about to go out. The dust boot had already broken down and torn so it was just a matter...

Mine will hit 200+ during city driving but the OP question was cruise and boost. Yes, the oil needs to get to ~200 to burn off any moisture but it doesn't need to stay there. Oh no! Not another...

Mine will hit 200+ during city driving but the OP question was cruise and boost. Yes, the oil needs to get to ~200 to burn off any moisture but it doesn't need to stay there. Oh no! Not another...

I'm not sure this will help but check your extension cables going to the MAFs. Those cables have given us problems.

My 8psi pulley is silver and most that I have seen on the forum are silver (bare aluminum). The color is just a coating (anodizing) and should not effect performance. The "high traction" pulleys are...

My FI test pipes and Mil Spec Cats came in yesterday. Again, FI has amazed me with their build quality. Kind of a shame to hide these under the car. Along with the FI goodies are my other mods to...

My latest Fast Intentions mod came in yesterday. I've had my TDX system for about a year and a half now and LOVE IT! I put a Stillen SC kit on last year along with an A2A kit so the stock cats had...

My latest Fast Intentions mod came in yesterday. I've had my TDX system for about a year and a half now and LOVE IT! I put a Stillen SC kit on last year along with an A2A kit so the stock cats had...