Mr. G. Brettin's Slow Motion Leg Hump

Rusty · 12-19-2019, 10:18 PM

Quote:

Originally Posted by gbrettin

That's a reason why I went with carbon kevlar.

Sent from my SM-G975U using Tapatalk

To make them thick enough for the stress. You would be spacing the bearings out too far. Then you will end up with alignment problems between the rotor and caliper. Pushing the rotor to the outside. The rotor would no longer be centered in the caliper.

gbrettin · 12-20-2019, 05:40 PM

Quote:

Originally Posted by Rusty

To make them thick enough for the stress. You would be spacing the bearings out too far. Then you will end up with alignment problems between the rotor and caliper. Pushing the rotor to the outside. The rotor would no longer be centered in the caliper.

I'll be sure to give it a good one over; but, the plate mounts completely flat and shouldn't be zero stress. Again, I'll look it over real good before anything happens. Thanks for the heads up.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Racing in Slow Motion IV	MightyBobo	The Lounge (Off Topic)	4	03-12-2013 08:12 PM
Racing In Slow Motion IV	Robert_K	The Lounge (Off Topic)	1	07-13-2012 11:01 AM
Slow shipping slow response slow everything	thispecialk	Nissan 370Z General Discussions	15	11-01-2010 08:23 PM
Racing in Slow Motion	MightyBobo	The Lounge (Off Topic)	2	12-17-2009 03:27 PM
IIHS Small Car Test: Three Gruesome Slow-Motion Crash Videos	AK370Z	Other Vehicles	13	04-15-2009 09:42 AM