|
Originally Posted by JLarson That is my entire job. One of our fabricators came in yesterday with questions about part marking location on a newly finished assembly. Turns out the
|
|||||||
 |
|
|
LinkBack | Thread Tools | Display Modes |
|
|
09-19-2018, 09:27 PM
|
#1 (permalink) | |
|
Ronin Samurai - Assassin
 
Join Date: Dec 2011
Location: Fayettenam,Pennsyltucky
Age: 69
Posts: 35,521
Drives: 2011 Nismo GM 6M
Rep Power: 2684439   |
Quote:
 I found control valves and check valves installed and welded in backwards. And this was after the welds was heat treated.  I wasn't QC there. I was just walking down the different systems and learning where everything was at and the flow paths. It was part of my training to operate the plant.
__________________
 浪人 - 殺し屋 "The Difficult Anytime, The Impossible By Appointment Only" http://www.the370z.com/members-370z-...o-journal.html |
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| The New "What did you do with your Z today" (with off topic replies) XXVIII | JARblue | The Lounge (Off Topic) | 10014 | 04-26-2018 10:07 AM |
| The New "What did you do with your Z today" (with off topic replies) XXVI | JARblue | The Lounge (Off Topic) | 10020 | 04-23-2017 11:37 AM |
| The New "What did you do with your Z today" (with off topic replies) XXIV | JARblue | The Lounge (Off Topic) | 10059 | 08-17-2016 12:08 PM |
| The New "What did you do with your Z today" (with off topic replies) XVIV | eastwest2300 | The Lounge (Off Topic) | 10005 | 09-11-2015 08:57 AM |
| The New "What did you do with your Z today" (with off topic replies) XIII | JARblue | The Lounge (Off Topic) | 10011 | 08-04-2014 04:16 PM |
11168Likes
Hybrid Mode
