11-26-2013, 04:50 PM
|
#11 (permalink)
|
|
Base Member
Join Date: Dec 2010
Location: Somewhere in Texas
Posts: 209
Drives: 2008 G35 Sedan
Rep Power: 15
|
Quote:
Originally Posted by cosmogirl
Well today was a good day, I have a few more options on the table. One being a long block out of a g37 with only 10k miles. I contacted s&r out of tampa to build it but he couldn't find pistons in a 10.1 compression. I worry that a 9.1 comp will make it laggy... Any thoughts. Keep in mind Iam looking boosting around 16psi.
|
My engine builder here in San Antonio runs a performance shop and is also a Certified Master Infiniti Technician. He HIGHLY recommends using CP Pistons for his GTR or VQ builds. He told me to go with a standard bore 10:1 or 9:5.1. I chose the latter. I asked him why not .20 oversized, he told me that he has built hundreds of blocks while at Infiniti and there was not one that needed to go with overbore pistons. He also mentioned of how thin the VQ sleeves already were in stock form. My 9:5.1 pistons are custom made from CP and purchased through Kyle at IPP. If SA, Texas isn't too far from you, I highly recommend my builder.
__________________
Eibach, Tanabe, Blitz, Vertini, GTM stage 1.5 SC, Aquamist, Invidia, Alto built 5AT, Edge Racing, Racelogic, GTM driveshaft, 440 whp in 101F TX heat..
|
|
|
Similar Threads
1131Likes
Threaded Mode
