|
On the driveshaft length… I measured the original driveshaft and just shortening it by 1/2” would be a really tight install on my car. The drive flange was very close
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
05-03-2024, 05:40 PM
|
#31 (permalink) |
|
Track Member
Join Date: Oct 2016
Location: OKC
Posts: 822
Drives: 2010 touring
Rep Power: 7843   |
On the driveshaft length…
I measured the original driveshaft and just shortening it by 1/2” would be a really tight install on my car. The drive flange was very close to the pinion shaft threads. Then, after measuring the two transmissions side by side several times it looked like 3/4” shorter would be a little better choice for my 2010 model touring. I have a 2016 3.69 mt rear diff, with a different than stock pinion angle also. That may be part of it.
__________________
NA on E85 - 12.402 @ 112 mph 100 shot E85 - 11.589 @ 117 mph JWT C2 cams rev Base Circle & Titan Valves |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| forced induction in australia | andylena | Australia/New Zealand | 23 | 09-15-2016 12:52 PM |
| Forced Induction Reliability | spearfish25 | Forced Induction | 58 | 09-08-2013 12:14 PM |
| Forced induction | stiso | Northern California Region | 8 | 11-28-2011 12:03 PM |
| Help don't want forced induction!!!!! | Mjthind | Engine & Drivetrain | 64 | 05-04-2011 01:00 PM |
| Forced induction | Seth G | Forced Induction | 13 | 04-09-2010 12:36 AM |
160Likes
Threaded Mode
