compound turbos?

Mitco39 · 01-25-2013, 04:44 PM

Quote:

Originally Posted by luigi90210

while the twin turbo kits offer good spool time, isnt twin turbo kits only good for low and mid power?
from what i understand a big single is good for mid and top end and a small single is good for low end so wouldnt a compound turbo setup offer the benefits of both?

i understand there is going to be some power loss because of restricted flow but wouldnt the power from boost make up for the lack of exhaust flow?

You also have to remember that its not so much boost as it is flow. A awesome flowing truck at say 30PSI can produce just as much HP as 60PSI, boost numbers does not necessarily mean power. Also with compound turbos (where one is not a VVT turbo) I could see issues with lag being caused from the small turbo having to get the larger turbo going. On Diesel trucks the vains in the smaller turbo can be controlled and thus you have much more control over the system.

I am just speaking from a truck standpoint since that is what I know, but I cant see it being much different for cars. If you want a sweet system put a supercharger on the car with twin turbos. You would have to figure out valving such that the supercharger is used in the lower rpms and then it gives way to the turbos. Again it comes down to room for piping.

Chuck33079 · 01-25-2013, 04:48 PM

Quote:

Originally Posted by Mitco39

You also have to remember that its not so much boost as it is flow. A awesome flowing truck at say 30PSI can produce just as much HP as 60PSI, boost numbers does not necessarily mean power.

I was just typing this. Even the wording was eerily similar.

Quote:

Originally Posted by luigi90210

while the twin turbo kits offer good spool time, isnt twin turbo kits only good for low and mid power?

No. Even with a smallish .64 gt28, there's a dramatic power increase all the way up to redline. It's all in the turbo sizing. You could get a smaller single turbo and see the same kinds of spool times you see with twin kits. You could get two larger twins that have the same amount of lag as a single.

Quote:

Originally Posted by Mitco39

If you want a sweet system put a supercharger on the car with twin turbos. You would have to figure out valving such that the supercharger is used in the lower rpms and then it gives way to the turbos.

This would be awesome. Have the turbos feed a roots blower.

TopgunZ · 01-28-2013, 10:49 PM

Quote:

Originally Posted by Chuck33079

This would be awesome. Have the turbos feed a roots blower.

Yeah, I did this with my 350z. Powerlab kit feeding the stillen.

Sh0velMan · 01-29-2013, 07:26 AM

Quote:

Originally Posted by TopgunZ

Yeah, I did this with my 350z. Powerlab kit feeding the stillen.

Uh, pics?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
How to remove streaks from rubbing compound?	babbagandu	Detailing / Washing / Waxing / Cosmetic Maintenance and Repair	17	07-02-2013 08:47 AM
Meguiar's Ultra Cut Compound vs diamond cut	duderevs	The Lounge (Off Topic)	0	11-29-2012 06:00 PM
EFR Turbos	frydrce	Forced Induction	34	08-30-2012 09:43 AM
somebody who knows a lot about turbos please help	kevin1985912	Forced Induction	15	10-05-2010 11:00 AM
General R-compound question	Nikon FM	Tires/Wheels	5	08-25-2010 08:03 PM