Boosted Performance single turbo build

Cell

Would there be any negative affect running a single BOV instead of dual?

Boosted Performance

Not at all. The air is being vented before the FMIC. The reason there was two BOV's in the prototype is due to them venting after the FMIC, where the charge air was split in to two.

99% of cars out there only use a single BOV to begin with. The 350z twin scroll kit uses one, as does the mid mount kit that I make for the 350z.

The Tial BOV's are also the largest you can get at 50mm with large vent ports..so there is a lot of room/area for the charge air to escape while the TB closes during shifts.

__________________
750WHP starting @ $7,500 to the door
FOR DETAILS VISIT: http://www.the370z.com/members/boosted-performance.html
FB: https://www.facebook.com/Boosted-Per...6303179791462/
IG @boostedperformanceyeg

Nixlimited

I would add that the single BOV pre-IC is a more efficient design too. There is no point in cooling charge air that is not going to be inducted. By venting before the IC, you save the IC the thermal load (i.e. heat soak) of that air.

__________________
Car Sold! Pleasure being a part of the Z community.
New ride: 2015 GT-R - 647 WHP / 641 WTQ (e85) & 543 WHP / 519 WTQ (91)