***Topgunz ROTREX C38R Supercharger Kit***

FrankEtier

I routed the exhaust from the BOV to dump under the car but it is still pretty noisy. What is the silencer you mention?

I've considered using the brake duct cutouts on my front bumper to allow additional direct cooler air flow to the filter..

So far no overheating issues on my setup.

__________________
‘14 Topgunz Speedworks Rotrex Supercharged VR30 7AT 370Z Magma Red.
@liquid.magma

14Q60awdSPORT

I got a 1.5" to 2" coupler to put on the end of the BOV, then a 2" to 2" coupler joint, then a 2" to 2.5" 180 degree elbow. then got a 2" ID PVC pipe approx 9" long, that goes inside the end of the 180degree elbow, capped the end of it. Drilled about 120 or so 1/4 holes in it (none aiming down at the IC), Got some 3" length x 2.6" OD with a 0.8" OD internal hole aquarium sponge filter that I stuffed inside the pvc pipe and then ran some zip ties through to keep them in place. and then I placed a 6.5" KN cone filter over the exposed end of the PVC to clean up the appearance and keep debris/water etc... off of it.

Now I honestly forget it even has a BOV. Probably 80% quieter vs without. Before it was so noisy and annoying in typical city driving, sounded like a jet 24/7.

I got some pictures up on the G forums someplace.

redondoaveb

Picture of the silencer I had on my bov

Attached Images

11192021185728.jpg (583.1 KB, 112 views)

__________________
Fast Intentions "Stage Seb" twin turbo #098- Specialty Z/Tial-Xonarotor/CJM/Ecutek/HKS/KW/SPL/Hotchkis/Rohana/Toyo
750whp/700ft.lbs