10-04-2019, 06:12 PM
|
#1 (permalink)
|
|
Enthusiast Member
Join Date: Nov 2016
Location: Washington
Posts: 285
Drives: 2014 Nismo
Rep Power: 27364
|
Quote:
Originally Posted by TBatt
What injectors are you using?
|
ID 1050x
Quote:
Originally Posted by WhiskeyHotel
Most injectors run a 12V source hot (key on) all the time. The ECU grounds the other pin to fire the injector. It sounds like you have a hard short to ground in the harness or an injector. Start by disconnecting the injector harness and see if it still blows the fuse. Divide and conquer.
(Typical injector impedance is 10-12 Ohms, so they should pull about 1 Amp if they are working properly.)
|
Yep that's the plan, unfortunately to do anything I have to pull that stupid *** stillen manifold off to get to anything which I'm not looking forward to. I never did any custom wiring with the injectors either, used a plug and play connector. Seems that may have not been the best idea
|
|
|
Similar Threads
16Likes
Hybrid Mode
