Fast Intentions Stage 2 TT build by MA-Motorsports.

Originally Posted by 1slow370

the trouble with the vvel is that to set it properly you don't need a consult3 but you do need to to have the actuators in the correct position before setting the sensors. this is typically achieved using the plastic assembly hold fixtures that ship on new vvel actuator assemblies but other methods can be used. then from a fresh assemble the car is powered up with the motors disconnected so that the vvel control module doesnt move them out of postion while monitoring the voltage from each position sensor and setting it to the correct value per fsm. all you do with the consult is open that log channel. once the sensors are calibrated you plug the motors back in so the vvel can start working. plugging in the motors and turning the ignition on before setting the sensors base reading will move the vvel system out of mechanical position which wil move the position of the sensore once calibrated. That is the sole reason nissan tells you to throw out the actuators any time you take them, or their sensors off the motor, and to never run the calibration twice as when not from a fresh assembly you can not control the base position of the vvel system. to be clear when the ignition turns on the control module commands the vvel motors to sensor zero so if the sensor are not in the correct position it will move the actuators to match where the sensors are set now and no amount of performing the calibration procedure will help. unless the changed the software passed 2013 last time i had hands on vvel engine that still used actuators was a long time ago.