Air Intake Temps- Stillen SC

MoulaZ · 01-01-2017, 12:23 AM

Quote:

Originally Posted by ChaseZ

Awesome! I'm in the middle of my SC install with the frozenboost. Crossed my mind to add a couple fans to pull the air through, but never got beyond the idea.

Oh and you won't fit that drain valve on the bottom unless you trim the bottom of your bumper cover and possibly the undertray. Put the plug back in

Honestly I was just messing around. Figured it couldn't hurt to try and might be fun/interesting lol. And given how high I mounted that Exchanger I don't have any issues with that drain tap. Oh, and I got this kit second hand, didn't come with the plug heh.

Forgive some of the photos, as they were mostly taken during the mock up phases. But I had to create a lot of clearance to make those damn fans fit, it was a very tight fit. Exchanger is kissing the front bar, and there about 10mm clearance from rear of fan to PS & Oil Coolers. PS Cooler had to come back a bit, had to cut some plastic where the lines come in and take the OEM brackets bend/flip and work some magic on them. Oil Cooler now sits on flush with Radiator Support... and it was just one extra Relay for the fans, they draw about 30A.

ChaseZ · 01-01-2017, 12:32 AM

Quote:

Originally Posted by MoulaZ

Honestly I was just messing around. Figured it couldn't hurt to try and might be fun/interesting lol. And given how high I mounted that Exchanger I don't have any issues with that drain tap.

Forgive some of the photos, as they were mostly taken during the mock up phases. But I had to create a lot of clearance to make those damn fans fit, it was a very tight fit. Exchanger is kissing the front bar, and there about 10mm clearance from rear of fan to PS & Oil Coolers. PS Cooler had to come back a bit, had to cut some plastic where the lines come in and take the OEM brackets bend/flip and work some magic on them. Oil Cooler now sits on flush with Radiator Support... and it was just one extra Relay for the fans, they draw about 30A.

My mock up experiences were rather similar. Surprised you can stuff it with that valve on though - I used the same bottom mounting points and I just barely clear it as it is, no way I'd fit the valve in there too.

I ended up mounting my oil cooler inverted and pushed back on the drivers side. Could probably clear fans if they were narrow but will see how it goes without them first.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
K&N 69-7078TS Intake or Stillen 370z Generation 3 Ultra Long Tube Dual Intake	ivan_star	Intake/Exhaust	15	01-23-2020 10:02 PM
Stillen SC A2W Plenum Temps	blobbish	Forced Induction	66	05-23-2016 11:14 AM
selling used stillen G3 intake.Motordyne M370 Intake Manifold	01206	Canada	4	04-14-2016 01:31 AM
Intake Temps?	johnwiki	Intake/Exhaust	8	06-09-2015 12:29 PM
Please help- Intake and hot temps	corbin09	Engine & Drivetrain	13	08-20-2011 01:13 PM