BP turbo build/advice

Boosted Performance · 04-12-2020, 11:11 PM

Quote:

Originally Posted by hc_416

I did get five and its really tough to get it on, I might just get a 6mm. even that is a little tight. Would that cause the gate not to work?

6mm (1/4") is the correct size.

Quote:

Originally Posted by hc_416

what are the best spark plugs to get for the kit, is it still the gtr plugs?

GTR plugs.

hc_416 · 04-13-2020, 10:20 PM

Quote:

Originally Posted by Boosted Performance

6mm (1/4") is the correct size.

GTR plugs.

I took off and popped open the waste gates again. I redid the clocking of the gate, clean the cap,s off and put on new tape, etc... One of the diaframes looks to have three creases and I would like to replace it. I measured the valve and it came out to 38 mm, I want to make sure that is the correct size so I order the right part. Once again thanks for all the help BP!

Boosted Performance · 04-13-2020, 11:34 PM

Quote:

Originally Posted by hc_416

I took off and popped open the waste gates again. I redid the clocking of the gate, clean the cap,s off and put on new tape, etc... One of the diaframes looks to have three creases and I would like to replace it. I measured the valve and it came out to 38 mm, I want to make sure that is the correct size so I order the right part. Once again thanks for all the help BP!

Contact Tial, these are MV-S wastegates. They will all have the same internals.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Turbo Build	davidson_z34	Forced Induction	33	11-12-2015 07:45 PM
Need Advice on Bottom End Build	604GZ	Engine & Drivetrain	5	04-07-2015 09:09 AM
Single turbo build	jlask370	Forced Induction	13	10-07-2013 12:41 PM
Need advice on stereo build....	mengel	Audio & Video	7	02-08-2011 08:24 AM