BP turbo build/advice

Boosted Performance · 04-12-2020, 11:11 PM

Quote:

Originally Posted by hc_416

I did get five and its really tough to get it on, I might just get a 6mm. even that is a little tight. Would that cause the gate not to work?

6mm (1/4") is the correct size.

Quote:

Originally Posted by hc_416

what are the best spark plugs to get for the kit, is it still the gtr plugs?

GTR plugs.

hc_416 · 04-13-2020, 10:20 PM

Quote:

Originally Posted by Boosted Performance

6mm (1/4") is the correct size.

GTR plugs.

I took off and popped open the waste gates again. I redid the clocking of the gate, clean the cap,s off and put on new tape, etc... One of the diaframes looks to have three creases and I would like to replace it. I measured the valve and it came out to 38 mm, I want to make sure that is the correct size so I order the right part. Once again thanks for all the help BP!

Boosted Performance · 04-13-2020, 11:34 PM

Quote:

Originally Posted by hc_416

I took off and popped open the waste gates again. I redid the clocking of the gate, clean the cap,s off and put on new tape, etc... One of the diaframes looks to have three creases and I would like to replace it. I measured the valve and it came out to 38 mm, I want to make sure that is the correct size so I order the right part. Once again thanks for all the help BP!

Contact Tial, these are MV-S wastegates. They will all have the same internals.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Turbo Build	davidson_z34	Forced Induction	33	11-12-2015 07:45 PM
Need Advice on Bottom End Build	604GZ	Engine & Drivetrain	5	04-07-2015 09:09 AM
Single turbo build	jlask370	Forced Induction	13	10-07-2013 12:41 PM
Need advice on stereo build....	mengel	Audio & Video	7	02-08-2011 08:24 AM