BP turbo build/advice

solidus · 05-04-2017, 06:10 AM

Well hell you should be good then. I say pull the wastegates, take them apart and make sure they're assembled corretly, put in the 5lb springs and then configure the lines the way I showed you. Then set up your boost controller correctly. You said you plumbed all the lines again but did you use new silicone or reuse the old? If you used the old lines did you carefully check each line for holes. I had a small hole near the passenger side wastegate that caused that wastegate to remain closed. It was tiny but I imagine with 23+ psi it expanded enough to cause a ruckus. You're past the hard stuff this is just where it get's tedius and irritating because now you just want to spool.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Turbo Build	davidson_z34	Forced Induction	33	11-12-2015 07:45 PM
Need Advice on Bottom End Build	604GZ	Engine & Drivetrain	5	04-07-2015 09:09 AM
Single turbo build	jlask370	Forced Induction	13	10-07-2013 12:41 PM
Need advice on stereo build....	mengel	Audio & Video	7	02-08-2011 08:24 AM

05-04-2017, 06:10 AM	#11 (permalink)
solidus Track Member Join Date: Oct 2014 Location: Orlando, Florida Posts: 694 Drives: 15' Nismo Black 6MT Rep Power: 10081	Well hell you should be good then. I say pull the wastegates, take them apart and make sure they're assembled corretly, put in the 5lb springs and then configure the lines the way I showed you. Then set up your boost controller correctly. You said you plumbed all the lines again but did you use new silicone or reuse the old? If you used the old lines did you carefully check each line for holes. I had a small hole near the passenger side wastegate that caused that wastegate to remain closed. It was tiny but I imagine with 23+ psi it expanded enough to cause a ruckus. You're past the hard stuff this is just where it get's tedius and irritating because now you just want to spool.