Anyone make lower seat rails for stock seats?

theDreamer · 02-27-2013, 10:27 AM

Quote:

Originally Posted by wdkwang

i'm 6'2" and have a longer torso. i only have a 1 finger gap between my head and the headliner so wearing a helmet for the track would be a no go. i took a look at how the seat rail is designed and realized that there is a possibility of lowering the seat height approx. 2 inches by cutting and modifying the rails. this would require a metal fabricator. luckily my friend's shop has one so i'll most likely be getting this done in the near future. i'll post pictures and results when i do.

The question though is, can what he does be made into a kit?
So anyone can go to a good shop, give them this plus instructions and modify the seat.

wdkwang · 02-27-2013, 05:10 PM

Quote:

Originally Posted by theDreamer

The question though is, can what he does be made into a kit?
So anyone can go to a good shop, give them this plus instructions and modify the seat.

Whether or not they decide to make it into a kit is something we'll have to see. As with anything, there has to be enough of a demand, and our cars aren't common.
Any good fabricator can do this.

Important notes:
1. I made that post earlier after looking at only the front of the seat at night with only my iphone flashlight to inspect the situation.
2. Today I checked both the front and rear of the rails and noticed that the floor pan is not even. There is a slope going downwards from the transmission tunnel towards the door, which means the rails are different sizes (one will have to be cut more than the other, which would make fabrication a tad more complicated).
3. There isn't as much of a clearance in the rear, which is the main factor in lowering your seat height. The rails sits on top of the floor pan hump (why there's even a damn hump is beyond me, just makes the seat that much higher), so even if it was cut so that the rail is completely leveled and resting on the hump I've only measured just under a 1.25" decrease. So I'm going to throw this up to my shop and see if they have any bright ideas. If that's all you need, then that's great but I'm looking for a 2" minimum drop, ideally 3".

If any of you guys go ahead with this before I do, post the results.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
FEELER: Touring Seats Black with rails!!! upgrade to touring NOW!	bullitt5897	Parts for sale (Private Classifieds)	42	08-18-2010 01:55 PM
FS: BRIDE Zeta III seats w/rails - Brand New!	M.Bonanni	Parts for sale (Private Classifieds)	17	02-24-2010 10:25 AM
I need your stock seat belts!!!	Customan	Track / Autocross / Drifting / Dragstrip	0	01-13-2010 07:00 PM
Sparco Milano Leather Seat? or Factory leather seats	giez	Exterior & Interior	17	11-14-2009 01:31 PM
Can i swap the stock cloth seats for leather seats??	Will3212	Exterior & Interior	14	09-25-2009 11:09 PM