|
Yes I basically cleaned the whole setup in an out. BOTH sides of the wheel hub and splines, plus the splines and flange on the axle itself. One of the
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
05-06-2018, 06:38 PM
|
#11 (permalink) |
|
Base Member
Join Date: Jul 2017
Location: Connecticut
Posts: 50
Drives: 10g374dr6mt
Rep Power: 9  |
Yes I basically cleaned the whole setup in an out. BOTH sides of the wheel hub and splines, plus the splines and flange on the axle itself. One of the axles had some black grime in the splines so I wire brushed it to clean metal first.
Not sure if this matters or not...the only thing I am thinking about is the oem washer that goes on before the axle nut. I noticed the washers on both sides were not flat, like the hub deformed them. So when I put everything back on each side, the washers were put so they looked like this on the hub []> if that makes sense. To kinda act as like a lock washer that gets crushed and holds the nut. Based on the wear stains on the washers, I think I flipped the washers the opposite way of how they were before I took them off. I don't remember how the washers were on my G35 when I did this year ago with that car. Last edited by AARONHL; 05-06-2018 at 06:45 PM. |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rear Axle Clunk (Please Report Here!) | RedZed34 | Engine & Drivetrain | 102 | 01-23-2017 04:51 PM |
| Attention Owners of 2010 370Z - Clunk Noise from Rear of Vehicle | jgalloner | Nissan 370Z General Discussions | 50 | 10-22-2016 03:43 PM |
| Rear coil sitting lower, slight click/clunk noise | NOFATCHX | Brakes & Suspension | 9 | 05-24-2013 11:48 AM |
| axle click? | ak808 | Brakes & Suspension | 9 | 01-28-2013 10:55 AM |
| Noise in 1st/2nd - NOT clunk, clank, whine | Davey | Engine & Drivetrain | 8 | 05-16-2011 01:44 PM |
133Likes
Threaded Mode
