|
Well it stopped raining so I went out and pulled one of the shims, it has 2 shims in it, started and idles the best it ever has, I have
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
04-25-2014, 08:13 PM
|
#27 (permalink) |
|
A True Z Fanatic
Join Date: Aug 2012
Location: Athens ohio
Posts: 1,213
Drives: Company car
Rep Power: 35   |
Well it stopped raining so I went out and pulled one of the shims, it has 2 shims in it, started and idles the best it ever has, I have always had a bit of a "wonky" idle as long as I can remember, its frigging perfect. I cannot hear the teeth hitting the sensor either...Im now thinking this has been an issue from day one of the flywheel and the sensor just now failed...I am still going to pull it out at work tomorrow and ispect if the groove is any deeper, if not I will repair the groove, visually inspect the flywheel from the check plate and if I see nothing conclusive I will order a backup sensor to keep in the car and boost on!
__________________
Swift|Koni|SPC| FI CBE|Z1|Stillen|Sbend|Zspeed|R/T Tuned|523 whp|458 tq|10.5 psi|SOLD  Joepro's Journal|Joepro's Boosted Performance Build |Pittsburgh-Western-Pa-Ohio-Wv-Group |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 370z wont start no power . Where to start | acracing118 | Exterior & Interior | 6 | 01-05-2013 06:37 PM |
| Car will start sometimes and not start, need advice | aragona7 | Nissan 370Z General Discussions | 11 | 03-08-2012 10:23 PM |
| If you had to start all over.... | saiko71 | Forced Induction | 31 | 03-27-2011 08:56 PM |
| cold start/push start | chops | Nissan 370Z General Discussions | 21 | 02-14-2011 03:40 AM |
| HELP: Car won't start! | tjlazer | Engine & Drivetrain | 41 | 04-06-2010 02:21 PM |
9Likes
Threaded Mode
