Prototype Aftermarket Clutch Master Cylinder - INSTALLED!

Alstann · 10-20-2013, 08:33 AM

Quote:

Originally Posted by 1slow370

something to double check when making a kit would be the flares on your short piece of hard line. i looked at the picture full sized and it appears to be single flared?

Yep, that is correct, it is a single flare. All the connections and couplers have/are done via straight single flares, and I went over it with a mechanic and he verified that as well. He also mentioned that if I did a bubble flare, it would have the same effect as a single flare, but I could do those as well if people would rather have it that way.

Quote:

Originally Posted by faceglide

SZ Clutch & Flywheel Kits for Z33 (07-08), Z34 & V36

Aren't many people running tilton already?

But f yeah, much more stout piece and def worth it. Lots of neat DIY going around lately, props to OP.

Well I guess the diff would be universal fitment vs a proprietary fitment like the SZP has? If thats the case, neato!

That would be for the Tilton clutch SLAVE cylinder (the one inside the transmission), my friend.

Joe@ZSpeed was the only person I know of that was doing design into an aftermarket master cylinder, but I don't think there have been new updates on that.

Also, it is highly recommended that people change the slave cylinder to aftermarket. Those usually break first.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Possible solutions to aftermarket clutch master cylinder	Alstann	Engine & Drivetrain	32	03-26-2015 08:59 PM
Wilwood Heavy-Duty Clutch Master Cylinder	djrelic	Engine & Drivetrain	25	08-29-2014 07:59 AM
Replacing the clutch line and clutch master cylinder	djrelic	DIY Section (Do-It-Yourself)	1	05-12-2014 01:46 PM
cluth master cylinder out?!?!?!?!?!	lllll210lllll	Engine & Drivetrain	59	05-09-2014 01:39 PM
Clutch master cylinder went out again	Zenmaster	Engine & Drivetrain	4	03-26-2013 12:54 AM