Engine problem - p0300 - Whats the fix?

ajc1884 · 01-30-2013, 11:07 AM

Help!!!
I just bought a used 2009, MT, sport package, w/ 35000 miles about a month ago.
Started her up one cold morning (about 30 degrees) and the service engine soon light came on immediately.
So i bought a code reader off of Amazon and it read p03000.

I was able to clear the code.
Havent been able to drive it yet cause its been snowing here...

I did let it idle to normal operating temperature and the light didnt come back on.

Should I be worried? What if it comes back on?
Please help.

isayimandrew · 01-30-2013, 11:09 AM

Quote:

Originally Posted by ajc1884

Help!!!
I just bought a used 2009, MT, sport package, w/ 35000 miles about a month ago.
Started her up one cold morning (about 30 degrees) and the service engine soon light came on immediately.
So i bought a code reader off of Amazon and it read p03000.

I was able to clear the code.
Havent been able to drive it yet cause its been snowing here...

I did let it idle to normal operating temperature and the light didnt come back on.

Should I be worried? What if it comes back on?
Please help.

Code : P0300 may also be accompanied by a 301-312. the number after the 3 indicated the misfiring cylinder

Definition : Random/Multiple Cylinder Misfire Detected

Symptom : Check Engine Light Illuminated and engine misfire, may also detect loss of power or hesitation while accelerating

Cause : The engine will set this code when a misfire is repeatedly detected.

Repair : Replace the failed component on that particular cylinder. Most commonly the Coil Pack

Damage if not repaired : Engine damage to the cylinders rings and damage to the catalytic converter from raw fuel not being burned, not to mention the poor performance and fuel mileage.

When you pull the check engine light codes and p0300 pops up you may ask yourself, What do I do now? See if there is an additional code such as p0302. The number that follows the 3 ( 02 in this case) identify's the problem cylinder. So the problem would be in the number 2 cylinder and in most cases can be cured by replacing the coil pack.

I suggest repairing the problem so in the future if your car has an additional problem it can illuminate the check engine light to let you know you need to fix an issue.

SPOHN · 01-30-2013, 12:11 PM

I personally would wait for it to come back on one more time. Then if so change all plugs a coil pack on that perticular cylinder.

nismonster · 01-30-2013, 12:11 PM

YMMV, but I bought some MAF cleaner for like 5 bucks from autozone and thoroughly cleaned the MAFs and hot-wires and it has not come on since.

SPOHN · 01-30-2013, 12:14 PM

^ this too

ajc1884 · 01-30-2013, 02:52 PM

Coil packs....? serious?
i just did some research on what is required to change spark plugs on the 370z and it looks like a pain in the butt.

Do you know if the strut brace needs to be removed, or can the plugs/coil packs be changed with it on?

DEpointfive0 · 01-30-2013, 02:53 PM

Quote:

Originally Posted by ajc1884

Coil packs....? serious?
i just did some research on what is required to change spark plugs on the 370z and it looks like a pain in the butt.

Do you know if the strut brace needs to be removed, or can the plugs/coil packs be changed with it on?

Try the MAF cleaning first

SPOHN · 01-30-2013, 02:55 PM

Yes it had to be removed. Along with throttle bodies and I can't remember if the manifold had to be to. It's not hard. Just some time.

ajc1884 · 02-14-2013, 11:35 AM

...update...

since erasing the code ive driven about 200 miles and the service engine soon light hasnt come back on.
everything seems perfect/normal.

It was really cold (near single digits) the morning I started it when the SES soon light came on. A fluke???..maybe the Z's dont like super cold temps.

370Z JT · 02-14-2013, 01:05 PM

Need to drive longer than 200 miles to really tell. Past 500 miles then you can rest easy.

USMCASA · 02-14-2013, 02:09 PM

^had the same issue. car sat for almost a week when it was really cold, started it up and had that code. car ran fine, cleared it out, hasn't came back since. that was over 10000 miles ago

Coon-azz · 02-14-2013, 02:12 PM

Quote:

Originally Posted by 370Z JT

Need to drive longer than 200 miles to really tell. Past 500 miles then you can rest easy.

Correct. Its my understanding that it takes 3 full drive cycles to reset the test.

ajc1884 · 02-14-2013, 03:33 PM

good to hear!

ajc1884 · 02-14-2013, 03:36 PM

Coon-azz..
I drove more than 3 driving cycles but the darn code never cleared itself. Everything sounded and operated fine so i cleared it with the code reader tool.

I think that particular code doesnt auto clear...... ? unlike what people say about the Small Emission Leak code.

Mt Tam I am · 02-14-2013, 04:06 PM

I had a CEL seemingly every time I went to the track. Not during the event but just before. The first 4 times only. Weird. It was the kind from the gas cap lock. It took awhile but always reset.

OP I hope it goes well for you.

01-30-2013, 11:07 AM	#1 (permalink)
ajc1884 Base Member Join Date: Jan 2013 Location: central, pennsylvania Posts: 191 Drives: 2012 370z Touring Rep Power: 12	Engine problem - p0300 - Whats the fix? Help!!! I just bought a used 2009, MT, sport package, w/ 35000 miles about a month ago. Started her up one cold morning (about 30 degrees) and the service engine soon light came on immediately. So i bought a code reader off of Amazon and it read p03000. I was able to clear the code. Havent been able to drive it yet cause its been snowing here... I did let it idle to normal operating temperature and the light didnt come back on. Should I be worried? What if it comes back on? Please help.

01-30-2013, 12:11 PM	#3 (permalink)
SPOHN A True Z Fanatic Join Date: Feb 2010 Location: Covington, GA Age: 45 Posts: 14,844 Drives: Waiting on next Z Rep Power: 221	I personally would wait for it to come back on one more time. Then if so change all plugs a coil pack on that perticular cylinder. __________________ Last edited by SPOHN; 01-30-2013 at 12:13 PM.

01-30-2013, 12:11 PM	#4 (permalink)
nismonster Base Member Join Date: Jun 2011 Location: Marietta, GA Posts: 177 Drives: 09 NISMO #349 Rep Power: 13	YMMV, but I bought some MAF cleaner for like 5 bucks from autozone and thoroughly cleaned the MAFs and hot-wires and it has not come on since. Wonka2581 and ajc1884 like this. __________________ SOLD 2009 MB Nismo # 349 \| Persimmon Touring Interior \| Whiteline Diff Bushings \| ZSpeed HD CSC \| SPL Rear Camber Links\| Michelin AS3 \| WickedCAS \| JL 13tw5-3 \| JL JX1000.1 \| Pioneer AVIC-X910BT

01-30-2013, 12:14 PM	#5 (permalink)
SPOHN A True Z Fanatic Join Date: Feb 2010 Location: Covington, GA Age: 45 Posts: 14,844 Drives: Waiting on next Z Rep Power: 221	^ this too __________________

01-30-2013, 02:55 PM	#8 (permalink)
SPOHN A True Z Fanatic Join Date: Feb 2010 Location: Covington, GA Age: 45 Posts: 14,844 Drives: Waiting on next Z Rep Power: 221	Yes it had to be removed. Along with throttle bodies and I can't remember if the manifold had to be to. It's not hard. Just some time. DEpointfive0 likes this. __________________

01-30-2013, 02:52 PM	#6 (permalink)
ajc1884 Base Member Join Date: Jan 2013 Location: central, pennsylvania Posts: 191 Drives: 2012 370z Touring Rep Power: 12	Coil packs....? serious? i just did some research on what is required to change spark plugs on the 370z and it looks like a pain in the butt. Do you know if the strut brace needs to be removed, or can the plugs/coil packs be changed with it on?

02-14-2013, 11:35 AM	#9 (permalink)
ajc1884 Base Member Join Date: Jan 2013 Location: central, pennsylvania Posts: 191 Drives: 2012 370z Touring Rep Power: 12	...update... since erasing the code ive driven about 200 miles and the service engine soon light hasnt come back on. everything seems perfect/normal. It was really cold (near single digits) the morning I started it when the SES soon light came on. A fluke???..maybe the Z's dont like super cold temps.

02-14-2013, 01:05 PM	#10 (permalink)
370Z JT A True Z Fanatic Join Date: Jan 2010 Location: United States Posts: 2,905 Drives: 370Z PW 7AT Rep Power: 378	Need to drive longer than 200 miles to really tell. Past 500 miles then you can rest easy. __________________ Click for My Journal Top Secret \| EVO-R \| Fujimura Auto \| Shine Auto \| Seibon \| MRWorks \| Swift \| SPC \| SSR \| UpRev \| Project Kics \| NST \| Titek \| Eibach \| Nismo \| Whiteline \| Quaife \| Invidia \| Fly1 \| CF Element \| Carbon Signal

02-14-2013, 02:09 PM	#11 (permalink)
USMCASA A True Z Fanatic Join Date: Nov 2009 Location: NC Posts: 1,152 Drives: 09 370z CY M6 Rep Power: 17	^had the same issue. car sat for almost a week when it was really cold, started it up and had that code. car ran fine, cleared it out, hasn't came back since. that was over 10000 miles ago OMGWTFBBQ and ajc1884 like this.

02-14-2013, 03:33 PM	#13 (permalink)
ajc1884 Base Member Join Date: Jan 2013 Location: central, pennsylvania Posts: 191 Drives: 2012 370z Touring Rep Power: 12	good to hear!

02-14-2013, 03:36 PM	#14 (permalink)
ajc1884 Base Member Join Date: Jan 2013 Location: central, pennsylvania Posts: 191 Drives: 2012 370z Touring Rep Power: 12	Coon-azz.. I drove more than 3 driving cycles but the darn code never cleared itself. Everything sounded and operated fine so i cleared it with the code reader tool. I think that particular code doesnt auto clear...... ? unlike what people say about the Small Emission Leak code.

02-14-2013, 04:06 PM	#15 (permalink)
Mt Tam I am A True Z Fanatic Join Date: Jun 2010 Location: California Posts: 10,709 Drives: 370Z T/S/N 6MT & XKE Rep Power: 3842	I had a CEL seemingly every time I went to the track. Not during the event but just before. The first 4 times only. Weird. It was the kind from the gas cap lock. It took awhile but always reset. OP I hope it goes well for you. __________________ "Does the carpet match the drapes? NO!!! I don't date bald women." Nissan Motorsports 34R Oil Cooler. Stillen CBE. Hotchkis Sport Sway Bars. KW Variant 3 Coilover System. Stillen Gen3 CAI. Michelin Pilot Super Sport. Stillen Brake Ducts. Carbotech™ XP10/XP8 Pads. Z1 Front Rotors. Z1 Stainless Brake Lines. Two degrees of camber

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
I have a serious engine problem	Mike	Engine & Drivetrain	56	02-19-2020 09:24 PM
Engine Problem?	SoCalBoy	Engine & Drivetrain	17	12-31-2012 01:22 AM
engine problem	Xsad	Engine & Drivetrain	2	01-30-2012 09:40 AM
Engine Note:Do I Have A Problem?	OldGuy	Nissan 370Z General Discussions	38	12-11-2009 07:10 PM
Help me! Engine oil problem!!	leepeen	Nissan 370Z General Discussions	72	07-03-2009 09:17 AM