06-29-2018, 12:39 PM
|
#34 (permalink)
|
|
A True Z Fanatic
Join Date: Jul 2011
Location: Dallas, TX
Posts: 3,270
Drives: 09 Nismo, 16 Nismo
Rep Power: 163996
|
Quote:
Originally Posted by ghotnit
Cold engine oil causes excessive frictional drag on the bearings and cylinder walls. A quality conventional motor oil will tolerate oil sump temperatures of up to 250 degrees, but starts breaking down over 275 degrees. The traditional approach is to try to hold oil temperatures between 230 and 260 degrees.Aug 29, 2013
What Is The Optimum Engine Oil Temperature? - Hot Rod Network |
Quote:
Originally Posted by Tractionless
Ok but the Z's ecu starts pulling timing (i.e. Power reduction) prior to oil breaking down. Cooler oil = more timing = more power.
|
Quote:
Originally Posted by Rusty
The ECU starts pulling timing around 240F. |
Not to revive this discussion, but don't forget the location of the oil temp reading. Our cars read oil temp right before oil enters back into the engine (coolest, especially after flowing through oil cooler), whereas some other cars read it right after oil flows out of their engines (hottest).
__________________
Setrab | RE-71 | SPL | JRZ | Nismo | ARK | Whiteline | RacingBrake | CJM Oil Pan | Ti shield
|
|
|
Similar Threads
28Likes
Threaded Mode
