![]() |
http://www.the370z.com/new-370z-owne...vdc-issue.html According to Nissan Technology Manager, once the VDC is off, EVERYTHING is shut off. I have sent them email and they assured me. But What Chris said, makes sense
|
![]() |
|
LinkBack | Thread Tools | Display Modes |
|
![]() |
#1 (permalink) |
Administrator
Join Date: Sep 2008
Location: NJ
Posts: 77
Drives: 03 Nissan 350Z CS M6
Rep Power: 10 ![]() |
![]()
Hello from sunny North Carolina -- 370Z Traction control vs VDC issue
According to Nissan Technology Manager, once the VDC is off, EVERYTHING is shut off. I have sent them email and they assured me. But What Chris said, makes sense too. I guess the ONLY way you can find out is go out and do more aggressive driving ![]() ![]() |
![]() |
![]() |
![]() |
#2 (permalink) | |
A True Z Fanatic
|
![]() Quote:
__________________
2013 Cadillac V-Wagon, RIP Z |
|
![]() |
![]() |
![]() |
#3 (permalink) |
Base Member
Join Date: Apr 2009
Location: Orange County, CA
Posts: 202
Drives: 09 Blue 6m 370zT/S/N
Rep Power: 17 ![]() |
![]()
Actually, I think that there is still some traction control on, even when you turn off VCD. I have noticed at the track that, although I have a lot more freedom to wiggle the back end, there have been a few moments where power was momentarily cut. It seemed to happen coming out of the same turn each time and I suspect that I was hitting a slightly uneven surface, bringing one wheel off the ground for a moment. It's not enough of an un-level surface to have an effect on exiting the corner, but the car reads a sudden extreme difference in wheel speed and compensates. Unfortunately, instead of just cutting power to that particular wheel, it drops my RPM limit for about 2 seconds (feels just like limp mode, except that oil temp is not the issue). Power is quickly restored and I just end up losing a little time.
It was very reproducible for me, depending on how fast I tried to exit the corner. The frustrating thing was that the issue was happening after I had wound out the wheel and was going almost completely straight, so the wheel skip has no negative effect on my handling. Very intrusive, in this case.
__________________
Proud owner of a new 167.2 inch, 3278 lb baby Z! Stillen CBE & G3 Intake // Stillen Lightweight pulley // Stillen Oil Cooler // Goodridge Braided Stainless Steel Brake Lines // ACT HDSS Clutch& Alum Flywheel |
![]() |
![]() |
![]() |
#4 (permalink) | |
Enthusiast Member
Join Date: Mar 2009
Location: USA
Posts: 468
Drives: 09 370Z Red AT Sport
Rep Power: 17 ![]() |
![]() Quote:
AK, why did you change your screen name?
__________________
Stillen CBE & G3 LTIs, Motordyne M370, Berk HFCs, H&R 15/20mm spacers, CiNcity headlights, yellow OEM strut brace, Password: JDM CF engine bay parts, EVO-R CF front bumper parts, CF "Z" badge, VIS CF hood, Fujimura CF "diffuser", Show-N-Go plate frame, Katzkin red interior, interior CF, Pioneer BT-90 full system, Viper SmartStart |
|
![]() |
![]() |
![]() |
Bookmarks |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Traction Control | joe370z | Australia/New Zealand | 23 | 02-28-2021 07:27 PM |
Anyone done completely blacked out headlights on Pearl White Z? | puckshaw | Exterior & Interior | 1 | 01-08-2010 08:33 PM |
Need specific winter tire / rim advice. I'm completely ignorant! | Portlis | Nissan 370Z General Discussions | 18 | 10-16-2009 12:51 AM |
Traction Control Question | YamahaR6 | Nissan 370Z General Discussions | 8 | 07-13-2009 01:18 PM |
Traction Control | ZSPEED | Nissan 370Z General Discussions | 10 | 06-03-2009 05:34 PM |