09-19-2022, 11:43 AM
|
#9 (permalink)
|
|
Base Member
Join Date: Mar 2020
Location: CA
Posts: 9
Drives: 09 Nissan 370Z White
Rep Power: 7
|
Quote:
Originally Posted by weebs25
You figure anything Out with this? Did you have this in for quite some time working? It’s tough to say it’s an internal adjustment if it worked fine for a while but it’s sounding it’s pushing to far forward one way or another. I’m doing the Install myself right now struggling the fork adjustment. Too far forward/no gap between plate.
|
I finally dropped the transmission and the pressure plate was loose. Two bolts on pressure plate were gone and the rest were finger right. There's uneven wear on PP teeth. The smooth shaft on trans where throwout bearing slides, isn't smooth anymore. Noticed my throwout bearing and sleeve were not meshed together completely or evenly. I looked in z1 website just for the cover/plate but it doesn't seem to be sold separately.
I think im gonna have to swap the whole thing for a zspeed cmak. Too much trouble with this kit.
Last edited by 370DriftZ; 09-19-2022 at 01:10 PM.
|
|
|
Similar Threads
8Likes
Threaded Mode
