Lightweight or Mid-weight flywheel?

Whjaxn17 · 05-07-2020, 08:43 AM

Quote:

Originally Posted by Dentt42

The response on my car was abysmal with the stock one. It was like they were trying to hinder performance where it wasn’t necessary.

Drivability and quiet. The extra weight of the OEM dual mass makes it easier to drive, specifically from a stop and has a urethane dampener that keeps it from chattering.

Dentt42 · 05-07-2020, 09:17 AM

Quote:

Originally Posted by Whjaxn17

Drivability and quiet. The extra weight of the OEM dual mass makes it easier to drive, specifically from a stop and has a urethane dampener that keeps it from chattering.

I know what they were thinking it would accomplish, but my EXEDY kit is significantly easier to drive, and it's got a solid flywheel that's 10 lbs. lighter. It doesn't have that weird over-center feel pressing and releasing the pedal, and feathers out smoothly even when I'm half-assing it expecting a little bit of bucking. I admit the pedal feel was likely partly due to wear, but like I noted in my earlier post, I (personally) don't feel any need to install an RJM pedal with the EXEDY kit as it functions now.

The only increase in noise is the tiniest bit of rattle when sitting at idle from the bouncing clutch fingers. You can hear it running the car next to a wall, such as pulling through a drive-through. It's got close to zero chatter, and I'd be so bold as to say less than the stock (maybe stock replacement) clutch that was in there before.

When I had my previous G37 I had them install a solid nodular flywheel from Z1 and a new stock replacement clutch. It rattled badly enough that I thought something was wrong at first, and then later found just life with these cars. Point is, if a specialty company like EXEDY can built a street clutch set that performs better in very way while remaining very easy to drive and stay quiet, I have no idea why a company like Nissan with millions in R&D could not.

Whjaxn17 · 05-07-2020, 09:38 AM

Quote:

Originally Posted by Dentt42

I know what they were thinking it would accomplish, but my EXEDY kit is significantly easier to drive, and it's got a solid flywheel that's 10 lbs. lighter. It doesn't have that weird over-center feel pressing and releasing the pedal, and feathers out smoothly even when I'm half-assing it expecting a little bit of bucking. I admit the pedal feel was likely partly due to wear, but like I noted in my earlier post, I (personally) don't feel any need to install an RJM pedal with the EXEDY kit as it functions now.

The only increase in noise is the tiniest bit of rattle when sitting at idle from the bouncing clutch fingers. You can hear it running the car next to a wall, such as pulling through a drive-through. It's got close to zero chatter, and I'd be so bold as to say less than the stock (maybe stock replacement) clutch that was in there before.

When I had my previous G37 I had them install a solid nodular flywheel from Z1 and a new stock replacement clutch. It rattled badly enough that I thought something was wrong at first, and then later found just life with these cars. Point is, if a specialty company like EXEDY can built a street clutch set that performs better in very way while remaining very easy to drive and stay quiet, I have no idea why a company like Nissan with millions in R&D could not.

Mine sounds like a diesel idle

but the 19 or 20 models are now coming with an Exedy clutch. I don't know how deep the changes go, so not sure if the flywheels are any lighter or different in any way, though.

Dentt42 · 05-07-2020, 12:10 PM

Quote:

Originally Posted by Whjaxn17

Mine sounds like a diesel idle

but the 19 or 20 models are now coming with an Exedy clutch. I don't know how deep the changes go to, so not sure if the flywheels are any lighter or different in any way, though.

That's exactly what the clutch in my previous G sounded like.

Swaffy · 06-01-2020, 05:44 PM

Hello, everyone. I didn't want to create a new thread (reducing clutter) so I'm asking here.

I'm looking for a good 10 to 12lb flywheel for my 2015 370z. Noise is no issue, I've been looking many places for one and can't seem to find one.

The only one I found is this, but I'm not even sure if it fits, nor the quality...
Competition Clutch: Forged Single Mass Flywheel

I heard about a South Bend stage 3 flywheel that weighs 12 lbs but I can't find any actual part for it (only a review).

Any help would be godly

Jimbo370 · 06-01-2020, 08:56 PM

here is 1 for u. https://www.z1motorsports.com/clutch...6.html:tiphat:

Whjaxn17 · 06-03-2020, 03:32 PM

Quote:

Originally Posted by Swaffy

Hello, everyone. I didn't want to create a new thread (reducing clutter) so I'm asking here.

I'm looking for a good 10 to 12lb flywheel for my 2015 370z. Noise is no issue, I've been looking many places for one and can't seem to find one.

The only one I found is this, but I'm not even sure if it fits, nor the quality...
Competition Clutch: Forged Single Mass Flywheel

I heard about a South Bend stage 3 flywheel that weighs 12 lbs but I can't find any actual part for it (only a review).

Any help would be godly

https://www.z1motorsports.com/z1-pro...el-p-9154.html

wdkwang · 01-21-2021, 10:40 PM

Quote:

Originally Posted by bcfromfl

I have the ZSpeed EZStreet Stage 2 clutch/flywheel combo, and I highly recommend this one for its overall performance. Joe told me he'd rate it conservatively to 400tq, but the pedal pressure is just a bit more than stock. No longer will you get the "rubber band" lash trying to ease into 1st, and it just feels plain solid.

The flywheel is 20 pounds, and I thought this would be too light. However, it is just right!

How's the chatter at idle? Thanks

Kamari · 02-06-2021, 06:35 PM

Quote:

Originally Posted by boosted180

I'm about to have a shop do my clutch/ flywheel/ CSC and trying to decide to go with a lightweight or "mid-weight" flywheel. Is the only disadvantage of the lightweight flywheel the noise? I was also told that the midweight is a waste of money to either stay stock or go to the lightweight one.

Any of you have the mid-weight and do you like it and did you feel a difference?

Thanks.

I have not used the car for anything other than street driving in recent years, but plan to get back to the track at some point. It doesn't have any big power mods and I will keep it that way.

What was your lead time in ordering the hardware? I'm stuck in the same situation with a bad CSC & clutch, and the recommendation is to swap out the flywheel as well. Problem is that I've looked at Z1, ZSpeed and a couple others but everybody is on back order. Meanwhile my car is sitting in a shop with a mechanic waiting on a decision. I'll be damned if I'm going to pay a grand for an OEM flywheel and another 1050 for a OEM clutch.

wdkwang · 02-06-2021, 07:16 PM

I haven't ordered it yet so I can't provide a lead time. However, I'm certain I'll be purchasing the ZSpeed kit based on all the reviews I've been reading.

JARblue · 02-07-2021, 09:48 AM

I specifically did not buy the "quiet disc" clutch package from Joe and asked for a light flywheel (ended up at 17lbs). I am disappointed that my clutch does not chatter at all

Rusty · 02-07-2021, 12:21 PM

Quote:

Originally Posted by JARblue

I specifically did not buy the "quiet disc" clutch package from Joe and asked for a light flywheel (ended up at 17lbs). I am disappointed that my clutch does not chatter at all

bcfromfl · 02-08-2021, 11:52 PM

Quote:

Originally Posted by wdkwang

How's the chatter at idle? Thanks

No chatter at idle. Sometimes a little chatter slipping into 1st, but barely noticeable. It operates EXACTLY like I prefer, and the operation is a thousand times more precise than OEM.

06-01-2020, 05:44 PM	#20 (permalink)
Swaffy Base Member Join Date: Mar 2019 Location: Cibolo, TX Posts: 9 Drives: 2020 Deep Blue Pearl Rep Power: 6	Hello, everyone. I didn't want to create a new thread (reducing clutter) so I'm asking here. I'm looking for a good 10 to 12lb flywheel for my 2015 370z. Noise is no issue, I've been looking many places for one and can't seem to find one. The only one I found is this, but I'm not even sure if it fits, nor the quality... Competition Clutch: Forged Single Mass Flywheel I heard about a South Bend stage 3 flywheel that weighs 12 lbs but I can't find any actual part for it (only a review). Any help would be godly __________________ 2020 Deep Blue Pearl, manual IG Lofi.z34

02-06-2021, 07:16 PM	#25 (permalink)
wdkwang Track Member Join Date: Nov 2010 Location: N/A Posts: 899 Drives: slidewayz Rep Power: 20	I haven't ordered it yet so I can't provide a lead time. However, I'm certain I'll be purchasing the ZSpeed kit based on all the reviews I've been reading. __________________ Powerhouse Amuse \| K&N Typhoon Intakes \| MotorDyne ART Pipes \| Borla Catback Exhaust \| B&M Short Shifter \| Intake Ducts \| Ichiba 25mm F/R Spacers \| Carbon Fiber Interior Vinyl Wrap \| Tints \| 10000k HIDs \| Vtak, yo!

02-07-2021, 09:48 AM	#26 (permalink)
JARblue A True Z Fanatic Join Date: Mar 2011 Location: Austin, TX Age: 43 Posts: 36,449 Drives: 11 Z34, 98 E36 M3 Rep Power: 2684440	I specifically did not buy the "quiet disc" clutch package from Joe and asked for a light flywheel (ended up at 17lbs). I am disappointed that my clutch does not chatter at all Rusty and Hotrodz like this. __________________ 2011 370Z 6MT Sport Gun Metallic \| ARC \| CJM \| Ecutek \| FI \| Fujimura \| R2C \| SPL \| Stillen \| TWM \| Z1 \| ZSpeed \|

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
lightweight flywheel good or bad?	mike12002us	Nissan 370Z General Discussions	25	07-21-2014 10:32 PM
Lightweight flywheel without the noise?	jmlenz	Forced Induction	30	03-19-2013 11:01 AM
[FOR SALE] JWT clutch and lightweight flywheel like new	tturbo370z	Parts for sale (Private Classifieds)	19	12-16-2012 02:28 PM
[WTB] Lightweight flywheel	biggestsack	Parts for sale (Private Classifieds)	0	06-11-2012 10:07 PM
[FOR SALE] JWT Aluminum Lightweight Flywheel	Staples	Parts for sale (Private Classifieds)	3	03-11-2012 02:11 PM

06-01-2020, 08:56 PM	#21 (permalink)
Jimbo370 Enthusiast Member Join Date: Jan 2014 Location: Florida Posts: 466 Drives: 09 black 370z MT Rep Power: 11	here is 1 for u. https://www.z1motorsports.com/clutch...6.html:tiphat: