RJM Clutch Pedal System for 370Z - Fully Customizable Clutch Feel & Stroke

Originally Posted by Ryan @ RJM

Hi Swindler,

Yes, you can simply loosen the 3-bolt connection between the upper and lower arm halves to alter the overall pedal height without changing anything else in the setup.

To adjust the AFP only a little bit as you say (about a tooth in either direction) you should be fine as long as you setup the clutch rod angle carefully to begin with. If it's already pushing at an off angle then moving a full tooth in the opposite direction might put it off angle quite a bit. The best thing to tell you is make the change and just use your best judgement. If it still appears to be pushing straight in/out after the change then no worries. If it's off you'll need to do a clutch rod angle adjustment procedure as well.



For the upper switch it is just that simple. Loosen the switch lock bolt to where you can push the mount up/down with a little force. Push the pedal down just slightly to take-up any linkage slack, push the mount down so the switch meets the rubber bumper and retighten the bolt to lock the adjustment. It took longer to type that then it does to actually do it.



Hope that helps!

Best Regards,

Ryan@RJM