DIY: Transmission Oil Change

juld0zer · 05-14-2013, 06:51 PM

I added an extra ~100mL to the gearbox and the oil dribbled out. Perhaps there was some volume of oil trapped in the mechanism of the pump, and the oil which cannot be picked up off the very bottom of the container.

I used an STM Tom Thumb pump:
http://www.onestoplubeshop.com.au/im...s/CA%20586.jpg

You guys in USA might have something similar. Minimal mess except when the nozzle end comes off the holder.

As for the diff, i couldnt get a torque wrench underneath to torque up the filler. I didnt jack the car up to do the diff so i just used a ratchet and made it snug. No leaks so far

NS370Z · 06-24-2013, 02:38 PM

For the guys that have done this job. Is there enough clearance in there to perhaps use a small funnel with a small clear hose attached at the bottom of the funnel? All I need is to be able to have the funnel just slightly higher than the fill hole. I can even angle the funnel a bit.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
what is good transmission oil?	leepeen	Nissan 370Z General Discussions	27	06-25-2009 02:40 AM
transmission noises	zoltan370z	Engine & Drivetrain	0	05-16-2009 08:49 AM
2 Questions concerning transmission	ikkeRR	Engine & Drivetrain	5	04-11-2009 10:02 PM
7 Speed Transmission	infiniti350gt	Engine & Drivetrain	0	03-08-2009 11:18 PM
Transmission?	370z2	Nissan 370Z General Discussions	10	01-29-2009 01:41 PM

05-14-2013, 06:51 PM	#1 (permalink)
juld0zer Enthusiast Member Join Date: Nov 2012 Location: Sydney Posts: 428 Drives: 11 Nissan 370Z MB M6 Rep Power: 140	I added an extra ~100mL to the gearbox and the oil dribbled out. Perhaps there was some volume of oil trapped in the mechanism of the pump, and the oil which cannot be picked up off the very bottom of the container. I used an STM Tom Thumb pump: http://www.onestoplubeshop.com.au/im...s/CA%20586.jpg You guys in USA might have something similar. Minimal mess except when the nozzle end comes off the holder. As for the diff, i couldnt get a torque wrench underneath to torque up the filler. I didnt jack the car up to do the diff so i just used a ratchet and made it snug. No leaks so far

06-24-2013, 02:38 PM	#2 (permalink)
NS370Z Enthusiast Member Join Date: Apr 2012 Location: Milky Way Posts: 249 Drives: Red Corvette C7 Rep Power: 15	For the guys that have done this job. Is there enough clearance in there to perhaps use a small funnel with a small clear hose attached at the bottom of the funnel? All I need is to be able to have the funnel just slightly higher than the fill hole. I can even angle the funnel a bit.