DIY: Oil Cooler (scratch built install, lottsa pics).....>.

cab83_750 · 03-02-2010, 02:05 PM

Quote:

Originally Posted by Modshack

Maybe my approach created a failsafe. I snugged up Ties in the valley areas, not tight enough to cut the hose on the ridges, but snug enough that the hose could nod expand over the ridge areas on the fitting. Dunno. Just seemed like a logical fail safe to me. I'll be pulling the lower cover this week to do my first change since the install (3500 miles) and will report back if there is any hose creep...

Modshack,

Parts Racer saw the 3 ties. They did say that those are NOT recommended. FYI, I am in contact with them regarding the hose(s) separating. They are supposed to be calling the vendor for input.

Modshack · 03-02-2010, 02:20 PM

Quote:

Originally Posted by cab83_750

Modshack,

Parts Racer saw the 3 ties. They did say that those are recommended. FYI, I am in contact with them regarding the hose(s) separating. They are supposed to be calling the vendor for input.

Interesting as that was an intuitive guess on my part and not in any instructions..

FWIW, I dropped the pan today and this is what I found: No hose creep at all. A small amount of sweating from the fitting into the Mocal (wiped off here), but not so much as a drop onto the cover below.. Perfectly dry on the cooler end. This at 3500 miles since the install..

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
DIY: Stillen 19 Row Oil Cooler Install - driver side (stock PS cooler unmoved)	djpathfinder	DIY Section (Do-It-Yourself)	21	11-30-2015 05:47 AM
Real Auto Dynamics built and R/T tuned built motor TT	Mr.Squeeze	Forced Induction	132	04-18-2014 06:09 PM
Anyone done a DIY for a 34r cooler install?	bigdog1250	DIY Section (Do-It-Yourself)	7	07-05-2012 10:38 AM
Oil Cooler Install	Zedx	Engine & Drivetrain	10	05-19-2011 02:35 AM
install oil cooler?	Mt Tam I am	Nissan 370Z General Discussions	5	08-25-2010 09:08 AM