|
Maybe my approach created a failsafe. I snugged up Ties in the valley areas, not tight enough to cut the hose on the ridges, but snug enough that the hose
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
03-01-2010, 11:44 AM
|
#10 (permalink) |
|
A True Z Fanatic
Join Date: Mar 2009
Location: Greenville NC
Posts: 2,883
Drives: 370Z Sport
Rep Power: 978   |
Maybe my approach created a failsafe. I snugged up Ties in the valley areas, not tight enough to cut the hose on the ridges, but snug enough that the hose could not expand over the ridge areas on the fitting. Dunno. Just seemed like a logical fail safe to me. I'll be pulling the lower cover this week to do my first change since the install (3500 miles) and will report back if there is any hose creep...
More than a few have installed this very set-up with no issues..  
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY: Stillen 19 Row Oil Cooler Install - driver side (stock PS cooler unmoved) | djpathfinder | DIY Section (Do-It-Yourself) | 21 | 11-30-2015 05:47 AM |
| Real Auto Dynamics built and R/T tuned built motor TT | Mr.Squeeze | Forced Induction | 132 | 04-18-2014 06:09 PM |
| Anyone done a DIY for a 34r cooler install? | bigdog1250 | DIY Section (Do-It-Yourself) | 7 | 07-05-2012 10:38 AM |
| Oil Cooler Install | Zedx | Engine & Drivetrain | 10 | 05-19-2011 02:35 AM |
| install oil cooler? | Mt Tam I am | Nissan 370Z General Discussions | 5 | 08-25-2010 09:08 AM |
17Likes
Threaded Mode
