DIY: Oil Pressure Gauge

40 to 332 · 12-19-2022, 04:17 PM

Quote:

Originally Posted by filip00

Hey, thanks for the help, but I still have a problem identifying this completely.

So...I have the FSM. I do get it - that I can put the (-) to any of the chassis parts, and that the (+) or the Orange wire can be connected to the ILL(+). So If I connect the (+) wire there, where do I put the Orange one? Or better yet - If I connect the Orange wire to it - then what do I connect the (+) to? Probably not the battery....or?

Connect the (-)wire to a ground location on the chassis.

Connect the (+) to an add-a-circuit that you can install into one of the circuits found in the fuse box located on the left-side of the driver's foot well. The individual circuits are identified on the inside of the fuse box cover. Pick one that is powered when the ignition is on.

Connect the orange wire to one of the wires shown as ILL(+) in the FSM. I chose the ILL(+) wire that illuminates the radio controls. If you want to do the same, follow the instructions in the FSM for accessing the rear of the radio. One of the connectors at the rear of the radio will contain the ILL(+) wire that you will need to tap into.

Trust this helps.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
370 oil pressure and AEM gauge	binto100	Nissan 370Z General Discussions	0	05-26-2010 07:04 PM
Oil Pressure Gauge	jpit	Engine & Drivetrain	3	03-16-2010 09:33 PM
Oil Pressure Gauge	jpit	Exterior & Interior	6	03-07-2010 08:36 PM
Oil Pressure Gauge	37Z	Exterior & Interior	0	06-14-2009 09:21 PM
What happened to the tire pressure gauge and speedo in the middle gauge cluster?	rbratton	Nissan 370Z General Discussions	33	01-24-2009 10:28 PM