Nissan 370Z Forum  

60K Mile Coolant Change

I just hit 64K miles and have done all the other 60K maintenance stuff except the coolant change. I have read the FSM and checked out many threads on the

Go Back   Nissan 370Z Forum > Nissan 370Z Tech Area > DIY Section (Do-It-Yourself)


Like Tree2Likes
  • 2 Post By Dreadnaught

Reply
 
LinkBack Thread Tools Display Modes
Old 02-05-2021, 02:12 PM   #1 (permalink)
Base Member
 
Join Date: Jan 2014
Location: California
Posts: 148
Drives: 09 Nissan 370Z GM M6
Rep Power: 6721
radensb has a reputation beyond reputeradensb has a reputation beyond reputeradensb has a reputation beyond reputeradensb has a reputation beyond reputeradensb has a reputation beyond reputeradensb has a reputation beyond reputeradensb has a reputation beyond reputeradensb has a reputation beyond reputeradensb has a reputation beyond reputeradensb has a reputation beyond reputeradensb has a reputation beyond repute
Default 60K Mile Coolant Change

I just hit 64K miles and have done all the other 60K maintenance stuff except the coolant change. I have read the FSM and checked out many threads on the forum about this and *think* I have a good understanding on what to do.

First off, many of the user preformed coolant changes discuss flushing the system with DI water (or distilled) to remove all of the old coolant vs removing the drain plugs on the block. It seems accessing the drain plugs on the block is a PITA. Is the multi-flush with DI an equivalent procedure?

I also plan to stick with Nissan Coolant. It seems people insist of flushing the coolant if using something other than Nissan OEM to ensure compatibility. My car is an '09 and has the green coolant in it, but it seems like the Blue stuff replaced it at some point (maybe when they went to a pressurized reservoir system?). I assume the newer Blue coolant is compatible with the green? If so, does that make the flush less important?

Many have talked about vacuum bleeding, but the FSM doesn't mention this and there is no bleed valve in the back heater hose. Is this something that is model year specific?

Thanks for the clarification!

My plan is to jack up the front of the car and drain the radiator. Then, flush once with DI water (for good measure) and replace the radiator hoses and thermostat (since its fairly easy to get to at that point). Finally, fill the radiator from the neck using Nissan Blue coolant with the top radiator bleed seal removed until it spills out. I got a radiator fill kit from Amazon to preform the "burp" procedure to finish filling the system and remove any air pockets while the front of the car is elevated.

Seems pretty straight forward and inline with other videos and discussions I have reviewed. Am I missing anything?

Thanks!

Last edited by radensb; 02-05-2021 at 02:14 PM.
radensb is offline   Reply With Quote
Old 02-13-2021, 07:16 AM   #2 (permalink)
A True Z Fanatic
 
Tractionless's Avatar
 
Join Date: Jan 2016
Location: Atlantic SE
Posts: 1,237
Drives: '10 K23 ST 7AT
Rep Power: 30525
Tractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond repute
Default

Get coolant test strips and see if it's still chemically balanced enough to stay in. No reason to change it if so.
__________________
Toys Not Tots
Tractionless is offline   Reply With Quote
Old 02-13-2021, 06:52 PM   #3 (permalink)
Base Member
 
Join Date: Jan 2014
Location: California
Posts: 148
Drives: 09 Nissan 370Z GM M6
Rep Power: 6721
radensb has a reputation beyond reputeradensb has a reputation beyond reputeradensb has a reputation beyond reputeradensb has a reputation beyond reputeradensb has a reputation beyond reputeradensb has a reputation beyond reputeradensb has a reputation beyond reputeradensb has a reputation beyond reputeradensb has a reputation beyond reputeradensb has a reputation beyond reputeradensb has a reputation beyond repute
Default

Quote:
Originally Posted by Tractionless View Post
Get coolant test strips and see if it's still chemically balanced enough to stay in. No reason to change it if so.
Thanks for the info. The main reason was because when I got my last oil change, the dealer pointed out that the thermostat housing body was showing signs of leaking and that my upper and lower hoses were showing signs of age. I also noticed that my overflow tank was bone dry.

They wanted close to $1K to do that work (lol). So, I ordered a new seal and hoses for ~$25 and was going replace the coolant anyway. It's probably long overdue. Interesting, I didn't know that you could test the coolant. Might give it a shot our of curiosity.
radensb is offline   Reply With Quote
Old 02-14-2021, 04:52 AM   #4 (permalink)
Track Member
 
Join Date: Dec 2009
Location: Farmington, Utah
Posts: 582
Drives: 14 SR 370z 6MT
Rep Power: 10139
Dreadnaught has a reputation beyond reputeDreadnaught has a reputation beyond reputeDreadnaught has a reputation beyond reputeDreadnaught has a reputation beyond reputeDreadnaught has a reputation beyond reputeDreadnaught has a reputation beyond reputeDreadnaught has a reputation beyond reputeDreadnaught has a reputation beyond reputeDreadnaught has a reputation beyond reputeDreadnaught has a reputation beyond reputeDreadnaught has a reputation beyond repute
Default

Based on my training and experience as a Technician for 8 years now, you can't go wrong with servicing fluids early according to manufacturer guidelines. Fluids are always getting better, but, I believe manufacturers put such high service intervals on fluids to save people money.

Once you drain your coolant, install a new o-ring on the drain plug and lubricate it with clean coolant before installing. Also install a new o-ring on the bleed plug and lubricate it with clean coolant. Just make sure the car is on level ground when filling the radiator. Fill the radiator slowly to help prevent catching air in the system. Get the bleed plug ready to install once coolant starts coming out. Keep filling the radiator and once the coolant is above the upper hose, install the radiator cap. Start your car and let the coolant get up to operating temperature. Feel the lower hose to make sure the thermostat opens. Finally check the coolant level in the reservoir and add to between the high and low lines. Take your car for a road test. Check your coolant level once more.

I serviced my coolant at 47k, 50k and 53k. So theoretically all of the old coolant should be out of the system per what the manual states the cooling system holds. I used about a gallon and a half of coolant each time. My car uses the blue coolant. Make sure the blue coolant can be used with the green coolant.

I also installed a new radiator cap and coolant reservoir cap at the 53k mark.

Also lubricate the upper and lower hose o-rings with clean coolant before I stalling them so the don't tear and end up with them leaking.

I know the blue coolant is a 50/50 mix so check to see if the green is as well. If you have to use the green coolant only add distilled water and NOT tap water if it does not already come in a 50/50 mix.
Rusty and old guy like this.
__________________
Ford Diesel and Heavy Line Technician at your service.

Last edited by Dreadnaught; 02-14-2021 at 04:59 AM. Reason: Cuhz
Dreadnaught is offline   Reply With Quote
Old 02-16-2021, 07:45 AM   #5 (permalink)
A True Z Fanatic
 
Tractionless's Avatar
 
Join Date: Jan 2016
Location: Atlantic SE
Posts: 1,237
Drives: '10 K23 ST 7AT
Rep Power: 30525
Tractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond reputeTractionless has a reputation beyond repute
Default

Quote:
Originally Posted by radensb View Post
Thanks for the info. The main reason was because when I got my last oil change, the dealer pointed out that the thermostat housing body was showing signs of leaking and that my upper and lower hoses were showing signs of age. I also noticed that my overflow tank was bone dry.

They wanted close to $1K to do that work (lol). So, I ordered a new seal and hoses for ~$25 and was going replace the coolant anyway. It's probably long overdue. Interesting, I didn't know that you could test the coolant. Might give it a shot our of curiosity.
Well then all of those other issues certainly change things.
__________________
Toys Not Tots
Tractionless is offline   Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Coolant Change Questions 40 to 332 DIY Section (Do-It-Yourself) 5 05-23-2017 12:37 PM
coolant change Jimbo370 DIY Section (Do-It-Yourself) 3 10-23-2015 02:15 PM
How often to change coolant when tracking Z_ealot Track / Autocross / Drifting / Dragstrip 12 10-16-2015 10:04 PM
coolant change. Jimbo370 Engine & Drivetrain 21 06-30-2015 05:30 PM
Coolant change CERBERUSlucid Engine & Drivetrain 21 02-11-2011 03:48 PM


All times are GMT -5. The time now is 11:17 AM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Search Engine Optimization by vBSEO 3.6.0 PL2