|
My rears were -2.2 degrees camber from factory. Factory tolerances are somthing like -1.6 to -2.2. Pretty wide tolerance and mine were at the upper range of normal. Once I
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
07-06-2009, 02:27 PM
|
#9 (permalink) |
|
Enthusiast Member
Join Date: May 2009
Location: Oildale, CA
Posts: 412
Drives: 2013 911 4S
Rep Power: 418   |
My rears were -2.2 degrees camber from factory. Factory tolerances are somthing like -1.6 to -2.2. Pretty wide tolerance and mine were at the upper range of normal. Once I lowered my car I had -2.6 on one side, -2.7 on the other. I got the spc camber kit and brought it back to -2.2. Before/after pictures are in this link.
|
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| DIY: SPL Parts Rear Camber Arms Install | M.Bonanni | DIY Section (Do-It-Yourself) | 38 | 11-21-2017 05:59 PM |
| DDM DIY - SPL Parts Rear Camber Arms Install | M.Bonanni | Brakes & Suspension | 7 | 10-04-2010 10:20 AM |
| THMotorsports Rear Camber Arms | travisjb | Brakes & Suspension | 5 | 05-28-2009 05:14 PM |
| SPC Rear Camber Kit Test Car Needed | THMotorsports | Brakes & Suspension | 3 | 03-03-2009 02:36 PM |
| SPC Rear Camber Kit Test Car needed! | THMotorsports | THMotorsports | 11 | 03-03-2009 02:32 PM |
Threaded Mode
