Voodoo13 camber rods

Orionx1

I tend to buy things cuz they look cool- I’m hoping that wasn’t a mistake in the case of my Voodoo13 camber rods. They look cool alright, but I fear the sway bar and the rods are going try to occupy the same space at the same time at the lowest point of the suspension travel. I’m sure the aluminum body of the camber arm will not survive that impact and most likely that aluminum arm is not going bend, it’s going to snap, leading to all kinds of unthinkable nightmares. When the car is at rest there is a ½” gap between the sway bar and the camber arm. I understand that the upper control arm will pull the sway bar up, via sway bar link, during suspension travel. Obviously the camber arms moves up with the suspension also. So my question is- Is the movement ratio about the same? In other words if the camber rod travels up 1” does the sway bar end also move 1” or something very close? I plan to take the spring out and manually run the suspension through its travel to verify there is no contact (hopefully). I was just wondering if anyone here has seen or run into this before.

Pic is a little blurry-

Attached Images

Voodoo13 Camber Rod.jpg (58.2 KB, 78 views)