BC ER, SPL Install and Adjust

sandersd

Installed the adjustment extenders that came with the shocks. To mark the place to drill the holes I took a sanding roll bit from my Dremel set, snipped it to an appropriate length and inserted it in the piece that fits over the adjustment knob at the top of the shock.

IMG_0868.JPG

Installed the cap on the shock, then bolted the shock into place. The pointed piece was just long enough to dent the underside of the plastic trim so I could see where to drill.

IMG_0867.JPG

I used a 1/4" bit to drill the hole.

IMG_0869.JPG

The hole is just big enough to fit the extender shaft and tube through. I trimmed off excess length so they would clear the hatch by about an inch.

IMG_0871.JPG

__________________
2014 370Z NISMO -- HKS Hi-Power Exhaust -- Swift Springs -- BC ER Coilovers -- SPL Suspension Components -- Nismo R-Tune Intake -- Seibon BD CF Hood