Bose amp bypass?

bigaudiofanat

Here you guys go.

https://youtu.be/yubzGi8UqZU

__________________
Need help with car audio or electronics? Let me know!! Need Help Let Me Know
Direct email address reimermatt@gmail.com
Owner of: Dynamic Mobile Audio Follow me below
https://www.facebook.com/Dynamicmobileaudio/

NissanParty

Hello, if I am only going to run a sub and two front components with crossover what is good to use? I really just need it to take two low voltage inputs from the stock HU and split it into sub and front speakers. I am thinking of using a JL 3 ch amp. Can I use a splitter and line driver and rely on the amps LPF and HPF to split the signal for front speakers and sub?

Here is a picture of what I am thinking... would this work:

The Weapon

Yes it would work, but i think a Line Driver would be more appropriate since you are grabbing low voltage from the headunit.

The lc2 is designed for speaker level output.

https://www.audiocontrol.com/car-aud...s/matrix-plus/

for the price i'd just get a the DM601 or DM801 gives you a lot more control and flexibility.

__________________
Boosted Performance Comp Turbo - Tuner- CJM Fuel Return- Modified Berk CBE- ZSpeed Stage 4 Clutch - Southbend Flywheel - Tuned by Seb ~650whp - HKS Coilovers - SPL - Focal Audio 4 way Active - Audiocontrol DSP - Work CR 2P

NissanParty

Thank you for the info! I will check out the DM601 and 801.

In my picture, that is an LC1, which is a line driver and LoC, from what I can tell. You are correct, the LC2 is a LoC only, but the LC1 has low level inputs as well, at least I think that is what they are. It has RCA inputs.

The Weapon

dang, didn't even realize that.. I thought it was the same as LC2.

Yeah that should work. Just add some rca plugs to the factory wires. make sure you get some that have two wires in them "twisted pair."

the Stock output is less than a Volt. I think its around 800mv. So that line out driver is really going to help in lowering the sound floor and prevent you from almost maxing out your gains on the amp.

__________________
Boosted Performance Comp Turbo - Tuner- CJM Fuel Return- Modified Berk CBE- ZSpeed Stage 4 Clutch - Southbend Flywheel - Tuned by Seb ~650whp - HKS Coilovers - SPL - Focal Audio 4 way Active - Audiocontrol DSP - Work CR 2P

bigaudiofanat

I would not use a splitter. I would take the full range low level signal and feed it into a DSP. I used the audison bitten but there are plenty of different DSP's out there. This will give you RCA outputs you can set to what you want example Front speakers off one set one set for subs one set for rears

__________________
Need help with car audio or electronics? Let me know!! Need Help Let Me Know
Direct email address reimermatt@gmail.com
Owner of: Dynamic Mobile Audio Follow me below
https://www.facebook.com/Dynamicmobileaudio/