|
I installed my tubes today. All in all, I'd say it went rather well. I did not remove the cross-member. I started to, but it seemed like a lot of
|
|||||||
|
|
LinkBack | Thread Tools | Display Modes |
04-29-2012, 07:51 PM
|
#14 (permalink) |
|
Base Member
Join Date: Jan 2012
Location: Reading, Pa
Posts: 248
Drives: 07 C6 M6 Cpe
Rep Power: 15  |
I installed my tubes today. All in all, I'd say it went rather well. I did not remove the cross-member. I started to, but it seemed like a lot of work and a real pain in the a**, so I figured if others were able to do it, why not try.
The thing I did do to make install easier is use a spray bottle with an alcohol solution in it. Alcohol evaporates very quickly, so I sprayed it on the silicone tube and the air box lead, to act as lubrication and get the tube to slide on easier. It worked. Just a bit of wrestling and some alcohol spray, and I had both sides done in about an hour.
__________________
'07 C6 6MT Coupe 03 Accord, DD, 400k miles |
|
|
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| UAM experience? | radek7633 | Exterior & Interior | 15 | 12-06-2011 08:24 PM |
| Any experience with NavTools? | Hugoneus | Nissan 370Z General Discussions | 3 | 01-17-2011 09:41 PM |
| My FIRST Z experience | ImportConvert | Nissan 370Z General Discussions | 17 | 06-26-2010 06:45 PM |
| My experience at Corner3garage | initialgemini | Corner3Garage | 0 | 02-17-2010 12:37 AM |
| Most Will Never Experience . . . | 2theextreme | The Lounge (Off Topic) | 29 | 09-18-2009 07:54 PM |
Threaded Mode
