[Official] 370z wheel fitment guide (pics/specs) only

john_d13

This thread was very helpful for me so I will share my Configuration.

Wheels - Varrstoen ES6
Offsets - R: 19x11 +20 (5mm spacer), F: 19x9.5 +22
Tires - Falkon 452 - 305/35/19 | 265/30/19
Suspension - BC BR Coil over setup. Lowered approximately 1.4" all around.
Camber settings - Adjusted to stock rear ony @1.8 Degree and 1.9 up front.

Fenders scrape a bit up front on larger bumps, any lower would be asking for trouble. No rolls. I had to raise the car .2" up front because of aggressive scraping inside the wheel wheels and bottoming out the front end, I'd recommend a stretch tire if your planning on going lower than 1.3".

Nut_N_Much

1) Vossen VFS-1 matte graphite

3) Front: 20x9.5 ET25 (mid-face concave), Rear: 20x12 ET30 (deep concave)

3) P Zero's

4) 255/30/20 Front. 305/30/20 Rear

5) Fortune 500 w/swifts

6)

7) Stock Fenders

8) No rubbing or issues

9) Perfectly inside fenders

__________________

Did new cool science stuff to the car !!!
http://www.the370z.com/mazoc/99606-z...y-14-17-a.html
http://www.the370z.com/diy-section-d...-w-videos.html

AntiVenom

looks effin great!

just double checking your tire specs though. if what you posted is accurate you are running about 4.6% difference front to rear. any codes? or is a 255/35s on the front.

__________________

BTFU

Would like to know too! I just upgraded to some Vossen's & Nitto's and am at 4.1% and have the ABS/Traction/E-brake codes...

DRFTR

I'm trying to decide on rear tire spec. have a 20x12 +20 rear wheel. can I fit a FATTER 305 on the 12" rear?? looking at Pirelli PZERO 305/30 and Michelin PSS. with my offset not sure if 315 or 325 will be too much tire to clear the fender. I have SPL camber arms but want to keep near factory specs. good stable ride platform.

I know some have cleared much larger tires but also don't want to get crazy. not an FI car (YET).