02-16-2011, 07:43 AM
|
#11 (permalink)
|
|
Base Member
Join Date: Aug 2010
Location: Atlanta
Posts: 203
Drives: 150cc Scooter
Rep Power: 16
|
Quote:
I just did an average from B1 to B2 and modified the whole B2
cylinder 1 is higher but I should set it to the 3 or 5 because they are the one receiving more air than the front one.
before any change , B2 was richer
after the change B1 was just a tiny bit leaner , this is why I only gave 1 cylinder to be richer
I'm trying to have both bank having the same fuel/air doing a data log with the MAF V. and WB
|
I understand. I think I'd try to get a little more specific on precisly which injector needed a boost, and which needed reduction. What you did is probably OK, but what if you lowered one injector in B2 when you should have lowered a different one?
Let me ask since I have not done this yet. If you raise or lower just one injector at a time, does it change how the engine runs at idle? Like, can you tell if the engine gets better or worse? If you can, then you might be able to go through one injector at a time and find the best selection for each.
In my opinion, the injector closest to the firewall which has less airflow and cooling would need more fuel then the ones closer to the radiator fan.
|
|
|
Similar Threads
Threaded Mode
