going square how did you like it?

newtonova822

hello,

Anyone else running Enkie rpf1 or others with a 18x10, 38 offset and spacers?

If so what spacers? Or can anyone help with what spacers I would need?

It would be greatly appreciated. I need to go with wheels quick and need some help.

And for mostly street do not want to put 10.5s on it.

Then there is forgestar F14s as well.. as second pic

Help please!

synolimit

I'd like to know as well. I wanted to sell my setup for that size but I'm 99% sure I'd have to run spacers front and rear defeating the whole purpose of the rpf1. Not only would I gain weight overall but I'd gain weight on the rear axle hurting performance.

__________________
13 370z-

wstar

Well my 18x10+34 (Forgestar) fit fine (if very slightly wide at stock camber) in the front, and use a 10mm spacer in the rear (but that's just cosmetics, you could go anywhere from 0 -> 20 on the rear spacer there and be fine). So I would think you could go 18x10+38 with a ~15mm spacer in the rear and be fine. They're just 4mm further to the inside than mine.

One of the bonuses of the cheap Forgstars is that they're made-to-order and you can spec whatever offset you like.

__________________
7AT Track Car!
Journal thread / Car setup details

Read T

I'm running the same setup (forgestar 18z10 +34). This is one of the cheaper square setups and not a bad wheel. No spacers needed to run them all around. As with any aftermarket wheel on this car though you will need extended studs (or bolt on spacers with longer studs) to get adequate thread engagement with aftermarket wheels. see below.

http://www.the370z.com/wheels-tires/...ud-length.html

__________________
2011 Nissan 370z Black Cherry Sport Pkg - Daily Driver, , 1960 Morgan +4 fun car, 1986 BMW 325ES, 1998 M3 and 1996 Spec Miata - Race Cars
SUPPORT TEAM WINSOME RACING - WRL, CHUMP, LEMONS